iwlagn: set tx_fifo for ampdu in transport layer
the mapping tx_queue -> fifo is really transport related. The upper
layer should be involved in such things.
Note that upon agg_disable, the queue is always mapped to fifo 0, but
this doesn't matter since when the queue will be setup again for a
new BA session, it will be configured to the good fifo anyway.
Signed-off-by: Emmanuel Grumbach <emmanuel.grumbach@intel.com>
Signed-off-by: Wey-Yi Guy <wey-yi.w.guy@intel.com>
Signed-off-by: John W. Linville <linville@tuxdriver.com>
diff --git a/drivers/net/wireless/iwlwifi/iwl-agn.c b/drivers/net/wireless/iwlwifi/iwl-agn.c
index e19ff11..d3e103c 100644
--- a/drivers/net/wireless/iwlwifi/iwl-agn.c
+++ b/drivers/net/wireless/iwlwifi/iwl-agn.c
@@ -2534,6 +2534,7 @@
struct iwl_priv *priv = hw->priv;
int ret = -EINVAL;
struct iwl_station_priv *sta_priv = (void *) sta->drv_priv;
+ struct iwl_rxon_context *ctx = iwl_rxon_ctx_from_vif(vif);
IWL_DEBUG_HT(priv, "A-MPDU action on addr %pM tid %d\n",
sta->addr, tid);
@@ -2587,8 +2588,8 @@
case IEEE80211_AMPDU_TX_OPERATIONAL:
buf_size = min_t(int, buf_size, LINK_QUAL_AGG_FRAME_LIMIT_DEF);
- iwl_trans_txq_agg_setup(trans(priv), iwl_sta_id(sta), tid,
- buf_size);
+ iwl_trans_txq_agg_setup(trans(priv), ctx->ctxid, iwl_sta_id(sta),
+ tid, buf_size);
/*
* If the limit is 0, then it wasn't initialised yet,