drm/i915: Add initial bits for VGA modesetting bringup on Sandybridge.
Signed-off-by: Eric Anholt <eric@anholt.net>
diff --git a/drivers/gpu/drm/i915/intel_crt.c b/drivers/gpu/drm/i915/intel_crt.c
index 79dd402..fccf074 100644
--- a/drivers/gpu/drm/i915/intel_crt.c
+++ b/drivers/gpu/drm/i915/intel_crt.c
@@ -39,7 +39,7 @@
struct drm_i915_private *dev_priv = dev->dev_private;
u32 temp, reg;
- if (IS_IRONLAKE(dev))
+ if (HAS_PCH_SPLIT(dev))
reg = PCH_ADPA;
else
reg = ADPA;
@@ -113,7 +113,7 @@
else
dpll_md_reg = DPLL_B_MD;
- if (IS_IRONLAKE(dev))
+ if (HAS_PCH_SPLIT(dev))
adpa_reg = PCH_ADPA;
else
adpa_reg = ADPA;
@@ -122,7 +122,7 @@
* Disable separate mode multiplier used when cloning SDVO to CRT
* XXX this needs to be adjusted when we really are cloning
*/
- if (IS_I965G(dev) && !IS_IRONLAKE(dev)) {
+ if (IS_I965G(dev) && !HAS_PCH_SPLIT(dev)) {
dpll_md = I915_READ(dpll_md_reg);
I915_WRITE(dpll_md_reg,
dpll_md & ~DPLL_MD_UDI_MULTIPLIER_MASK);
@@ -136,11 +136,11 @@
if (intel_crtc->pipe == 0) {
adpa |= ADPA_PIPE_A_SELECT;
- if (!IS_IRONLAKE(dev))
+ if (!HAS_PCH_SPLIT(dev))
I915_WRITE(BCLRPAT_A, 0);
} else {
adpa |= ADPA_PIPE_B_SELECT;
- if (!IS_IRONLAKE(dev))
+ if (!HAS_PCH_SPLIT(dev))
I915_WRITE(BCLRPAT_B, 0);
}
@@ -202,7 +202,7 @@
u32 hotplug_en;
int i, tries = 0;
- if (IS_IRONLAKE(dev))
+ if (HAS_PCH_SPLIT(dev))
return intel_ironlake_crt_detect_hotplug(connector);
/*
@@ -524,7 +524,7 @@
&intel_output->enc);
/* Set up the DDC bus. */
- if (IS_IRONLAKE(dev))
+ if (HAS_PCH_SPLIT(dev))
i2c_reg = PCH_GPIOA;
else {
i2c_reg = GPIOA;