TTY: serial, move locking in uart_close
So now, when we handle CLOSING flag, there is no point to hold
port->mutex over the start of uart_close.
Yes, there are still several things to reason about:
* port->count etc is and always was protected by a spinlock
* ->stop_rx is protected by a spinlock. Otherwise it would
race with interrupts.
* uart_wait_until_sent -- that one is already called without
port->mutex from set_termios and tty_set_ldisc. Should anything
be protected there, it would be tx_empty. And by a spinlock.
8250 does this internally...
This step is needed to fix system stalls. To not create an AB-BA lock
dependency (see next patches).
Signed-off-by: Jiri Slaby <jslaby@suse.cz>
Acked-by: Arnd Bergmann <arnd@arndb.de>
Signed-off-by: Greg Kroah-Hartman <gregkh@suse.de>
diff --git a/drivers/tty/serial/serial_core.c b/drivers/tty/serial/serial_core.c
index 849bd0d..0464360 100644
--- a/drivers/tty/serial/serial_core.c
+++ b/drivers/tty/serial/serial_core.c
@@ -1253,7 +1253,6 @@
pr_debug("uart_close(%d) called\n", uport->line);
- mutex_lock(&port->mutex);
spin_lock_irqsave(&port->lock, flags);
if (tty_hung_up_p(filp)) {
@@ -1312,6 +1311,7 @@
uart_wait_until_sent(tty, uport->timeout);
}
+ mutex_lock(&port->mutex);
uart_shutdown(tty, state);
uart_flush_buffer(tty);