MIPS: Netlogic: Make number of nodes configurable
There can be 1, 2 or 4 SoCs(nodes) in a multi-chip XLP board. Add an
option for multi-chip boards in case of XLP, and make the number of
nodes configurable.
Signed-off-by: Jayachandran C <jchandra@broadcom.com>
Patchwork: http://patchwork.linux-mips.org/patch/4470
Signed-off-by: John Crispin <blogic@openwrt.org>
diff --git a/arch/mips/netlogic/Kconfig b/arch/mips/netlogic/Kconfig
index 8059eb7..3c05bf9 100644
--- a/arch/mips/netlogic/Kconfig
+++ b/arch/mips/netlogic/Kconfig
@@ -9,6 +9,34 @@
This DTB will be used if the firmware does not pass in a DTB
pointer to the kernel. The corresponding DTS file is at
arch/mips/netlogic/dts/xlp_evp.dts
+
+config NLM_MULTINODE
+ bool "Support for multi-chip boards"
+ depends on NLM_XLP_BOARD
+ default n
+ help
+ Add support for boards with 2 or 4 XLPs connected over ICI.
+
+if NLM_MULTINODE
+choice
+ prompt "Number of XLPs on the board"
+ default NLM_MULTINODE_2
+ help
+ In the multi-node case, specify the number of SoCs on the board.
+
+config NLM_MULTINODE_2
+ bool "Dual-XLP board"
+ help
+ Support boards with upto two XLPs connected over ICI.
+
+config NLM_MULTINODE_4
+ bool "Quad-XLP board"
+ help
+ Support boards with upto four XLPs connected over ICI.
+
+endchoice
+
+endif
endif
config NLM_COMMON