veth: add netpoll support
It is trivial to add netpoll support to veth, since
it is not a stacked device, we don't need to setup and
clean up netpoll.
Reported-by: Stefan Priebe <s.priebe@profihost.ag>
Cc: "David S. Miller" <davem@davemloft.net>
Cc: Neil Horman <nhorman@tuxdriver.com>
Acked-by: Neil Horman <nhorman@tuxdriver.com>
Signed-off-by: Cong Wang <xiyou.wangcong@gmail.com>
Acked-by: Neil Horman <nhorman@tuxdriver.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/veth.c b/drivers/net/veth.c
index b4a10bc..9b945e6 100644
--- a/drivers/net/veth.c
+++ b/drivers/net/veth.c
@@ -248,6 +248,21 @@
free_netdev(dev);
}
+#ifdef CONFIG_NET_POLL_CONTROLLER
+static void veth_poll_controller(struct net_device *dev)
+{
+ /* veth only receives frames when its peer sends one
+ * Since it's a synchronous operation, we are guaranteed
+ * never to have pending data when we poll for it so
+ * there is nothing to do here.
+ *
+ * We need this though so netpoll recognizes us as an interface that
+ * supports polling, which enables bridge devices in virt setups to
+ * still use netconsole
+ */
+}
+#endif /* CONFIG_NET_POLL_CONTROLLER */
+
static const struct net_device_ops veth_netdev_ops = {
.ndo_init = veth_dev_init,
.ndo_open = veth_open,
@@ -257,6 +272,9 @@
.ndo_get_stats64 = veth_get_stats64,
.ndo_set_rx_mode = veth_set_multicast_list,
.ndo_set_mac_address = eth_mac_addr,
+#ifdef CONFIG_NET_POLL_CONTROLLER
+ .ndo_poll_controller = veth_poll_controller,
+#endif
};
#define VETH_FEATURES (NETIF_F_SG | NETIF_F_FRAGLIST | NETIF_F_ALL_TSO | \