mtd: denali: detect the number of banks before resetting NAND
Commit c89eeda810f0ec4f0eee0206ebb79e476df9f83e (mtd: denali: detect the
number of banks) introduced runtime detection of the number of banks.
However, denali_nand_reset() uses uses denanli_nand_info::max_banks so
we need to detect the maximum number of banks before doing the reset.
Signed-off-by: Jamie Iles <jamie@jamieiles.com>
Signed-off-by: Artem Bityutskiy <Artem.Bityutskiy@nokia.com>
diff --git a/drivers/mtd/nand/denali.c b/drivers/mtd/nand/denali.c
index eebdfb5..3984d48 100644
--- a/drivers/mtd/nand/denali.c
+++ b/drivers/mtd/nand/denali.c
@@ -1346,6 +1346,7 @@
* */
denali->bbtskipbytes = ioread32(denali->flash_reg +
SPARE_AREA_SKIP_BYTES);
+ detect_max_banks(denali);
denali_nand_reset(denali);
iowrite32(0x0F, denali->flash_reg + RB_PIN_ENABLED);
iowrite32(CHIP_EN_DONT_CARE__FLAG,
@@ -1356,7 +1357,6 @@
/* Should set value for these registers when init */
iowrite32(0, denali->flash_reg + TWO_ROW_ADDR_CYCLES);
iowrite32(1, denali->flash_reg + ECC_ENABLE);
- detect_max_banks(denali);
denali_nand_timing_set(denali);
denali_irq_init(denali);
}