gpio/nomadik: add function to read GPIO pull down status
Signed-off-by: Rickard Andersson <rickard.andersson@stericsson.com>
Reviewed-by: Martin Persson <martin.persson@stericsson.com>
[Split off from larger patch]
Signed-off-by: Linus Walleij <linus.walleij@linaro.org>
Signed-off-by: Grant Likely <grant.likely@secretlab.ca>
diff --git a/drivers/gpio/gpio-nomadik.c b/drivers/gpio/gpio-nomadik.c
index 3802047..4961ef9 100644
--- a/drivers/gpio/gpio-nomadik.c
+++ b/drivers/gpio/gpio-nomadik.c
@@ -57,6 +57,7 @@
u32 fwimsc;
u32 slpm;
u32 enabled;
+ u32 pull_up;
};
static struct nmk_gpio_chip *
@@ -103,16 +104,22 @@
u32 pdis;
pdis = readl(nmk_chip->addr + NMK_GPIO_PDIS);
- if (pull == NMK_GPIO_PULL_NONE)
+ if (pull == NMK_GPIO_PULL_NONE) {
pdis |= bit;
- else
+ nmk_chip->pull_up &= ~bit;
+ } else {
pdis &= ~bit;
+ }
+
writel(pdis, nmk_chip->addr + NMK_GPIO_PDIS);
- if (pull == NMK_GPIO_PULL_UP)
+ if (pull == NMK_GPIO_PULL_UP) {
+ nmk_chip->pull_up |= bit;
writel(bit, nmk_chip->addr + NMK_GPIO_DATS);
- else if (pull == NMK_GPIO_PULL_DOWN)
+ } else if (pull == NMK_GPIO_PULL_DOWN) {
+ nmk_chip->pull_up &= ~bit;
writel(bit, nmk_chip->addr + NMK_GPIO_DATC);
+ }
}
static void __nmk_gpio_make_input(struct nmk_gpio_chip *nmk_chip,
@@ -921,6 +928,25 @@
}
}
+/*
+ * Read the pull up/pull down status.
+ * A bit set in 'pull_up' means that pull up
+ * is selected if pull is enabled in PDIS register.
+ * Note: only pull up/down set via this driver can
+ * be detected due to HW limitations.
+ */
+void nmk_gpio_read_pull(int gpio_bank, u32 *pull_up)
+{
+ if (gpio_bank < NUM_BANKS) {
+ struct nmk_gpio_chip *chip = nmk_gpio_chips[gpio_bank];
+
+ if (!chip)
+ return;
+
+ *pull_up = chip->pull_up;
+ }
+}
+
static int __devinit nmk_gpio_probe(struct platform_device *dev)
{
struct nmk_gpio_platform_data *pdata = dev->dev.platform_data;