[PATCH] mmc: Add support for mmc v4 high speed mode
This adds support for the high-speed modes defined by mmc v4
(assuming the host controller is up to it). On a TI sdhci controller,
it improves read speed from 1.3MBps to 2.3MBps. The TI controller can
only go up to 24MHz, but everything helps. Another person has taken
this basic patch and used it on a Nokia 770 to get a bigger boost
because that controller can run at 48MHZ.
Signed-off-by: Philip Langdale <philipl@overt.org>
Signed-off-by: Pierre Ossman <drzeus@drzeus.cx>
diff --git a/include/linux/mmc/card.h b/include/linux/mmc/card.h
index 991a373..ce25256 100644
--- a/include/linux/mmc/card.h
+++ b/include/linux/mmc/card.h
@@ -39,6 +39,10 @@
write_misalign:1;
};
+struct mmc_ext_csd {
+ unsigned int hs_max_dtr;
+};
+
struct sd_scr {
unsigned char sda_vsn;
unsigned char bus_widths;
@@ -62,11 +66,13 @@
#define MMC_STATE_BAD (1<<2) /* unrecognised device */
#define MMC_STATE_SDCARD (1<<3) /* is an SD card */
#define MMC_STATE_READONLY (1<<4) /* card is read-only */
+#define MMC_STATE_HIGHSPEED (1<<5) /* card is in mmc4 highspeed mode */
u32 raw_cid[4]; /* raw card CID */
u32 raw_csd[4]; /* raw card CSD */
u32 raw_scr[2]; /* raw card SCR */
struct mmc_cid cid; /* card identification */
struct mmc_csd csd; /* card specific */
+ struct mmc_ext_csd ext_csd; /* mmc v4 extended card specific */
struct sd_scr scr; /* extra SD information */
};
@@ -75,12 +81,14 @@
#define mmc_card_bad(c) ((c)->state & MMC_STATE_BAD)
#define mmc_card_sd(c) ((c)->state & MMC_STATE_SDCARD)
#define mmc_card_readonly(c) ((c)->state & MMC_STATE_READONLY)
+#define mmc_card_highspeed(c) ((c)->state & MMC_STATE_HIGHSPEED)
#define mmc_card_set_present(c) ((c)->state |= MMC_STATE_PRESENT)
#define mmc_card_set_dead(c) ((c)->state |= MMC_STATE_DEAD)
#define mmc_card_set_bad(c) ((c)->state |= MMC_STATE_BAD)
#define mmc_card_set_sd(c) ((c)->state |= MMC_STATE_SDCARD)
#define mmc_card_set_readonly(c) ((c)->state |= MMC_STATE_READONLY)
+#define mmc_card_set_highspeed(c) ((c)->state |= MMC_STATE_HIGHSPEED)
#define mmc_card_name(c) ((c)->cid.prod_name)
#define mmc_card_id(c) ((c)->dev.bus_id)