diff --git a/drivers/w1/Kconfig b/drivers/w1/Kconfig
index 4baf61a..5e61ed5 100644
--- a/drivers/w1/Kconfig
+++ b/drivers/w1/Kconfig
@@ -11,63 +11,7 @@
 	  This W1 support can also be built as a module.  If so, the module
 	  will be called wire.ko.
 
-config W1_MATROX
-	tristate "Matrox G400 transport layer for 1-wire"
-	depends on W1 && PCI
-	help
-	  Say Y here if you want to communicate with your 1-wire devices
-	  using Matrox's G400 GPIO pins.
-
-	  This support is also available as a module.  If so, the module
-	  will be called matrox_w1.ko.
-
-config W1_DS9490
-	tristate "DS9490R transport layer driver"
-	depends on W1 && USB
-	help
-	  Say Y here if you want to have a driver for DS9490R UWB <-> W1 bridge.
-
-	  This support is also available as a module.  If so, the module
-	  will be called ds9490r.ko.
-
-config W1_DS9490_BRIDGE
-	tristate "DS9490R USB <-> W1 transport layer for 1-wire"
-	depends on W1_DS9490
-	help
-	  Say Y here if you want to communicate with your 1-wire devices
-	  using DS9490R USB bridge.
-
-	  This support is also available as a module.  If so, the module
-	  will be called ds_w1_bridge.ko.
-
-config W1_THERM
-	tristate "Thermal family implementation"
-	depends on W1
-	help
-	  Say Y here if you want to connect 1-wire thermal sensors to you
-	  wire.
-
-config W1_SMEM
-	tristate "Simple 64bit memory family implementation"
-	depends on W1
-	help
-	  Say Y here if you want to connect 1-wire
-	  simple 64bit memory rom(ds2401/ds2411/ds1990*) to you wire.
-
-config W1_DS2433
-	tristate "4kb EEPROM family support (DS2433)"
-	depends on W1
-	help
-	  Say Y here if you want to use a 1-wire
-	  4kb EEPROM family device (DS2433).
-
-config W1_DS2433_CRC
-	bool "Protect DS2433 data with a CRC16"
-	depends on W1_DS2433
-	select CRC16
-	help
-	  Say Y here to protect DS2433 data with a CRC16.
-	  Each block has 30 bytes of data and a two byte CRC16.
-	  Full block writes are only allowed if the CRC is valid.
+source drivers/w1/masters/Kconfig
+source drivers/w1/slaves/Kconfig
 
 endmenu