[PATCH] W1: Move w1 bus master code into 'w1/masters' and move w1 slave code into 'w1/slaves'
Signed-off-by: Ben Gardner <bgardner@wabtec.com>
Signed-off-by: Evgeniy Polyakov <johnpol@2ka.mipt.ru>
Signed-off-by: Greg Kroah-Hartman <gregkh@suse.de>
diff --git a/drivers/w1/slaves/Kconfig b/drivers/w1/slaves/Kconfig
new file mode 100644
index 0000000..f9d4c91
--- /dev/null
+++ b/drivers/w1/slaves/Kconfig
@@ -0,0 +1,38 @@
+#
+# 1-wire slaves configuration
+#
+
+menu "1-wire Slaves"
+ depends on W1
+
+config W1_SLAVE_THERM
+ tristate "Thermal family implementation"
+ depends on W1
+ help
+ Say Y here if you want to connect 1-wire thermal sensors to you
+ wire.
+
+config W1_SLAVE_SMEM
+ tristate "Simple 64bit memory family implementation"
+ depends on W1
+ help
+ Say Y here if you want to connect 1-wire
+ simple 64bit memory rom(ds2401/ds2411/ds1990*) to you wire.
+
+config W1_SLAVE_DS2433
+ tristate "4kb EEPROM family support (DS2433)"
+ depends on W1
+ help
+ Say Y here if you want to use a 1-wire
+ 4kb EEPROM family device (DS2433).
+
+config W1_SLAVE_DS2433_CRC
+ bool "Protect DS2433 data with a CRC16"
+ depends on W1_DS2433
+ select CRC16
+ help
+ Say Y here to protect DS2433 data with a CRC16.
+ Each block has 30 bytes of data and a two byte CRC16.
+ Full block writes are only allowed if the CRC is valid.
+
+endmenu