[SERIAL] sunsab: Get line numbers and table sizing correct.
Table sizing code should look for "se" not "su" nodes.
The chip at the lower address should get the first index.
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/serial/sunsab.c b/drivers/serial/sunsab.c
index cb55d81..dc673e1 100644
--- a/drivers/serial/sunsab.c
+++ b/drivers/serial/sunsab.c
@@ -1047,12 +1047,13 @@
up = &sunsab_ports[inst * 2];
err = sunsab_init_one(&up[0], op,
- sizeof(union sab82532_async_regs),
+ 0,
(inst * 2) + 0);
if (err)
return err;
- err = sunsab_init_one(&up[1], op, 0,
+ err = sunsab_init_one(&up[1], op,
+ sizeof(union sab82532_async_regs),
(inst * 2) + 1);
if (err) {
of_iounmap(up[0].port.membase,
@@ -1061,8 +1062,8 @@
return err;
}
- uart_add_one_port(&sunsab_reg, &up[1].port);
uart_add_one_port(&sunsab_reg, &up[0].port);
+ uart_add_one_port(&sunsab_reg, &up[1].port);
dev_set_drvdata(&op->dev, &up[0]);
@@ -1117,7 +1118,7 @@
int err;
num_channels = 0;
- for_each_node_by_name(dp, "su")
+ for_each_node_by_name(dp, "se")
num_channels += 2;
for_each_node_by_name(dp, "serial") {
if (of_device_is_compatible(dp, "sab82532"))