mac80211: allow no mac address until firmware load
Originally by Johannes Berg. This patch adds support for devices that do not
report their MAC address until the firmware is loaded. While the address is not
known, a multicast on is used.
Signed-off-by: Luis Carlos Cobo <luisca@cozybit.com>
Signed-off-by: John W. Linville <linville@tuxdriver.com>
diff --git a/net/mac80211/main.c b/net/mac80211/main.c
index f5537f9..93dcdc2 100644
--- a/net/mac80211/main.c
+++ b/net/mac80211/main.c
@@ -187,9 +187,15 @@
u32 changed = 0;
int res;
bool need_hw_reconfig = 0;
+ u8 null_addr[ETH_ALEN] = {0};
sdata = IEEE80211_DEV_TO_SUB_IF(dev);
+ /* fail early if user set an invalid address */
+ if (compare_ether_addr(dev->dev_addr, null_addr) &&
+ !is_valid_ether_addr(dev->dev_addr))
+ return -EADDRNOTAVAIL;
+
/* we hold the RTNL here so can safely walk the list */
list_for_each_entry(nsdata, &local->interfaces, list) {
struct net_device *ndev = nsdata->dev;
@@ -270,6 +276,36 @@
ieee80211_led_radio(local, local->hw.conf.radio_enabled);
}
+ /*
+ * Check all interfaces and copy the hopefully now-present
+ * MAC address to those that have the special null one.
+ */
+ list_for_each_entry(nsdata, &local->interfaces, list) {
+ struct net_device *ndev = nsdata->dev;
+
+ /*
+ * No need to check netif_running since we do not allow
+ * it to start up with this invalid address.
+ */
+ if (compare_ether_addr(null_addr, ndev->dev_addr) == 0)
+ memcpy(ndev->dev_addr,
+ local->hw.wiphy->perm_addr,
+ ETH_ALEN);
+ }
+
+ if (compare_ether_addr(null_addr, local->mdev->dev_addr) == 0)
+ memcpy(local->mdev->dev_addr, local->hw.wiphy->perm_addr,
+ ETH_ALEN);
+
+ /*
+ * Validate the MAC address for this device.
+ */
+ if (!is_valid_ether_addr(dev->dev_addr)) {
+ if (!local->open_count && local->ops->stop)
+ local->ops->stop(local_to_hw(local));
+ return -EADDRNOTAVAIL;
+ }
+
switch (sdata->vif.type) {
case IEEE80211_IF_TYPE_VLAN:
/* no need to tell driver */
@@ -975,6 +1011,8 @@
dev->open = ieee80211_open;
dev->stop = ieee80211_stop;
dev->destructor = free_netdev;
+ /* we will validate the address ourselves in ->open */
+ dev->validate_addr = NULL;
}
/* everything else */