MIPS: MTX-1: Make au1000_eth probe all PHY addresses
When au1000_eth probes the MII bus for PHY address, if we do not set
au1000_eth platform data's phy_search_highest_address, the MII probing
logic will exit early and will assume a valid PHY is found at address 0.
For MTX-1, the PHY is at address 31, and without this patch, the link
detection/speed/duplex would not work correctly.
CC: stable@kernel.org
Signed-off-by: Florian Fainelli <florian@openwrt.org>
To: linux-mips@linux-mips.org
Patchwork: https://patchwork.linux-mips.org/patch/2111/
Signed-off-by: Ralf Baechle <ralf@linux-mips.org>
diff --git a/arch/mips/alchemy/mtx-1/platform.c b/arch/mips/alchemy/mtx-1/platform.c
index e30e42a..956f94621 100644
--- a/arch/mips/alchemy/mtx-1/platform.c
+++ b/arch/mips/alchemy/mtx-1/platform.c
@@ -28,6 +28,8 @@
#include <linux/mtd/physmap.h>
#include <mtd/mtd-abi.h>
+#include <asm/mach-au1x00/au1xxx_eth.h>
+
static struct gpio_keys_button mtx1_gpio_button[] = {
{
.gpio = 207,
@@ -140,10 +142,17 @@
&mtx1_mtd,
};
+static struct au1000_eth_platform_data mtx1_au1000_eth0_pdata = {
+ .phy_search_highest_addr = 1,
+ .phy1_search_mac0 = 1,
+};
+
static int __init mtx1_register_devices(void)
{
int rc;
+ au1xxx_override_eth_cfg(0, &mtx1_au1000_eth0_pdata);
+
rc = gpio_request(mtx1_gpio_button[0].gpio,
mtx1_gpio_button[0].desc);
if (rc < 0) {