[ARM] 4435/1: PXA: remove PXA_INTERNAL_IRQS
1. define PXA_GPIO_IRQ_BASE to be right after the internal IRQs,
and define PXA_GPIO_IRQ_NUM to be 128 for all PXA2xx variants
2. make the code specific to the high IRQ numbers (32..64) to be
PXA27x specific
3. add a function pxa_init_irq_high() to initialize the internal
high IRQ chip, the invoke of this function could be moved to
PXA27x specific initialization code
Signed-off-by: eric miao <eric.miao@marvell.com>
Signed-off-by: Russell King <rmk+kernel@arm.linux.org.uk>
diff --git a/include/asm-arm/arch-pxa/irqs.h b/include/asm-arm/arch-pxa/irqs.h
index dc4e7548..a07fe0f 100644
--- a/include/asm-arm/arch-pxa/irqs.h
+++ b/include/asm-arm/arch-pxa/irqs.h
@@ -55,18 +55,15 @@
#ifdef CONFIG_PXA27x
#define IRQ_TPM PXA_IRQ(32) /* TPM interrupt */
#define IRQ_CAMERA PXA_IRQ(33) /* Camera Interface */
-
-#define PXA_INTERNAL_IRQS 34
-#else
-#define PXA_INTERNAL_IRQS 32
#endif
-#define GPIO_2_x_TO_IRQ(x) \
- PXA_IRQ((x) - 2 + PXA_INTERNAL_IRQS)
+#define PXA_GPIO_IRQ_BASE (64)
+#define PXA_GPIO_IRQ_NUM (128)
+
+#define GPIO_2_x_TO_IRQ(x) (PXA_GPIO_IRQ_BASE + (x))
#define IRQ_GPIO(x) (((x) < 2) ? (IRQ_GPIO0 + (x)) : GPIO_2_x_TO_IRQ(x))
-#define IRQ_TO_GPIO_2_x(i) \
- ((i) - IRQ_GPIO(2) + 2)
+#define IRQ_TO_GPIO_2_x(i) ((i) - PXA_GPIO_IRQ_BASE)
#define IRQ_TO_GPIO(i) (((i) < IRQ_GPIO(2)) ? ((i) - IRQ_GPIO0) : IRQ_TO_GPIO_2_x(i))
#if defined(CONFIG_PXA25x)
@@ -81,7 +78,7 @@
* these. If you need more, increase IRQ_BOARD_END, but keep it
* within sensible limits.
*/
-#define IRQ_BOARD_START (IRQ_GPIO(PXA_LAST_GPIO) + 1)
+#define IRQ_BOARD_START (PXA_GPIO_IRQ_BASE + PXA_GPIO_IRQ_NUM)
#define IRQ_BOARD_END (IRQ_BOARD_START + 16)
#define IRQ_SA1111_START (IRQ_BOARD_END)