tree 8d0e3ad337e44e9e06caabd5f0667f27e9ddaca3
parent dbd70fb499952d0ba282f0159dafacfc31d50313
author Heiko Carstens <heiko.carstens@de.ibm.com> 1208411173 +0200
committer Heiko Carstens <heiko.carstens@de.ibm.com> 1208411221 +0200

[S390] Vertical cpu management.

If vertical cpu polarization is active then the hypervisor will
dispatch certain cpus for a longer time than other cpus for maximum
performance. For example if a guest would have three virtual cpus,
each of them with a share of 33 percent, then in case of vertical
cpu polarization all of the processing time would be combined to a
single cpu which would run all the time, while the other two cpus
would get nearly no cpu time.

There are three different types of vertical cpus: high, medium and
low. Low cpus hardly get any real cpu time, while high cpus get a
full real cpu. Medium cpus get something in between.

In order to switch between the two possible modes (default is
horizontal) a 0 for horizontal polarization or a 1 for vertical
polarization must be written to the dispatching sysfs attribute:

/sys/devices/system/cpu/dispatching

The polarization of each single cpu can be figured out by the
polarization sysfs attribute of each cpu:

/sys/devices/system/cpu/cpuX/polarization

horizontal, vertical:high, vertical:medium, vertical:low or unknown.

When switching polarization the polarization attribute may contain
the value unknown until the configuration change is done and the
kernel has figured out the new polarization of each cpu.

Note that running a system with different types of vertical cpus may
result in significant performance regressions. If possible only one
type of vertical cpus should be used. All other cpus should be
offlined.

Signed-off-by: Martin Schwidefsky <schwidefsky@de.ibm.com>
Signed-off-by: Heiko Carstens <heiko.carstens@de.ibm.com>