regulator: core: Use a struct to pass in regulator runtime configuration
Rather than adding new arguments to regulator_register() every time we
want to add a new bit of dynamic information at runtime change the function
to take these via a struct. By doing this we avoid needing to do further
changes like the recent addition of device tree support which required each
regulator driver to be updated to take an additional parameter.
The regulator_desc which should (mostly) be static data is still passed
separately as most drivers are able to configure this statically at build
time.
Signed-off-by: Mark Brown <broonie@opensource.wolfsonmicro.com>
diff --git a/drivers/regulator/fixed.c b/drivers/regulator/fixed.c
index 9a7d70a..b47b005a 100644
--- a/drivers/regulator/fixed.c
+++ b/drivers/regulator/fixed.c
@@ -167,6 +167,7 @@
{
struct fixed_voltage_config *config;
struct fixed_voltage_data *drvdata;
+ struct regulator_config cfg = { };
int ret;
if (pdev->dev.of_node)
@@ -247,9 +248,12 @@
drvdata->desc.ops = &fixed_voltage_ops;
}
- drvdata->dev = regulator_register(&drvdata->desc, &pdev->dev,
- config->init_data, drvdata,
- pdev->dev.of_node);
+ cfg.dev = &pdev->dev;
+ cfg.init_data = config->init_data;
+ cfg.driver_data = drvdata;
+ cfg.of_node = pdev->dev.of_node;
+
+ drvdata->dev = regulator_register(&drvdata->desc, &cfg);
if (IS_ERR(drvdata->dev)) {
ret = PTR_ERR(drvdata->dev);
dev_err(&pdev->dev, "Failed to register regulator: %d\n", ret);