ARM: dts: cfa10036: Use pinctrl for power led
The leds-gpio driver recently got pinctrl support, so setup the power
led gpio muxing through pinctrl.
This avoids the warning:
leds-gpio leds.X: pins are not configured from the driver
Signed-off-by: Maxime Ripard <maxime.ripard@free-electrons.com>
Signed-off-by: Shawn Guo <shawn.guo@linaro.org>
diff --git a/arch/arm/boot/dts/imx28-cfa10036.dts b/arch/arm/boot/dts/imx28-cfa10036.dts
index c03a577..3a28077 100644
--- a/arch/arm/boot/dts/imx28-cfa10036.dts
+++ b/arch/arm/boot/dts/imx28-cfa10036.dts
@@ -22,6 +22,18 @@
apb@80000000 {
apbh@80000000 {
+ pinctrl@80018000 {
+ led_pins_cfa10036: leds-10036@0 {
+ reg = <0>;
+ fsl,pinmux-ids = <
+ 0x3043 /* MX28_PAD_AUART1_RX__GPIO_3_4 */
+ >;
+ fsl,drive-strength = <0>;
+ fsl,voltage = <1>;
+ fsl,pull-up = <0>;
+ };
+ };
+
ssp0: ssp@80010000 {
compatible = "fsl,imx28-mmc";
pinctrl-names = "default";
@@ -43,6 +55,8 @@
leds {
compatible = "gpio-leds";
+ pinctrl-names = "default";
+ pinctrl-0 = <&led_pins_cfa10036>;
power {
gpios = <&gpio3 4 1>;