[WAN]: converting generic HDLC to use netif_dormant*()
This patch converts generic HDLC (and WAN drivers using it) from
hdlc_set_carrier() to netif_dormant*() interface.
WAN hardware drivers should now use netif_carrier_on|off() like
other network drivers.
Signed-off-by: Krzysztof Halasa <khc@pm.waw.pl>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/wan/c101.c b/drivers/net/wan/c101.c
index c92ac9f..2c09ec9 100644
--- a/drivers/net/wan/c101.c
+++ b/drivers/net/wan/c101.c
@@ -116,27 +116,33 @@
#include "hd6457x.c"
+static inline void set_carrier(port_t *port)
+{
+ if (!sca_in(MSCI1_OFFSET + ST3, port) & ST3_DCD)
+ netif_carrier_on(port_to_dev(port));
+ else
+ netif_carrier_off(port_to_dev(port));
+}
+
+
static void sca_msci_intr(port_t *port)
{
- struct net_device *dev = port_to_dev(port);
- card_t* card = port_to_card(port);
- u8 stat = sca_in(MSCI1_OFFSET + ST1, card); /* read MSCI ST1 status */
+ u8 stat = sca_in(MSCI1_OFFSET + ST1, port); /* read MSCI ST1 status */
/* Reset MSCI TX underrun status bit */
- sca_out(stat & ST1_UDRN, MSCI0_OFFSET + ST1, card);
+ sca_out(stat & ST1_UDRN, MSCI0_OFFSET + ST1, port);
if (stat & ST1_UDRN) {
- struct net_device_stats *stats = hdlc_stats(dev);
+ struct net_device_stats *stats = hdlc_stats(port_to_dev(port));
stats->tx_errors++; /* TX Underrun error detected */
stats->tx_fifo_errors++;
}
/* Reset MSCI CDCD status bit - uses ch#2 DCD input */
- sca_out(stat & ST1_CDCD, MSCI1_OFFSET + ST1, card);
+ sca_out(stat & ST1_CDCD, MSCI1_OFFSET + ST1, port);
if (stat & ST1_CDCD)
- hdlc_set_carrier(!(sca_in(MSCI1_OFFSET + ST3, card) & ST3_DCD),
- dev);
+ set_carrier(port);
}
@@ -190,7 +196,7 @@
sca_out(IE1_UDRN, MSCI0_OFFSET + IE1, port);
sca_out(IE0_TXINT, MSCI0_OFFSET + IE0, port);
- hdlc_set_carrier(!(sca_in(MSCI1_OFFSET + ST3, port) & ST3_DCD), dev);
+ set_carrier(port);
printk(KERN_DEBUG "0x%X\n", sca_in(MSCI1_OFFSET + ST3, port));
/* enable MSCI1 CDCD interrupt */
@@ -378,7 +384,7 @@
}
sca_init_sync_port(card); /* Set up C101 memory */
- hdlc_set_carrier(!(sca_in(MSCI1_OFFSET + ST3, card) & ST3_DCD), dev);
+ set_carrier(card);
printk(KERN_INFO "%s: Moxa C101 on IRQ%u,"
" using %u TX + %u RX packets rings\n",