drivers: use req op accessor
The req operation REQ_OP is separated from the rq_flag_bits
definition. This converts the block layer drivers to
use req_op to get the op from the request struct.
Signed-off-by: Mike Christie <mchristi@redhat.com>
Reviewed-by: Hannes Reinecke <hare@suse.com>
Signed-off-by: Jens Axboe <axboe@fb.com>
diff --git a/drivers/scsi/sd.c b/drivers/scsi/sd.c
index f459dff..c8dc221 100644
--- a/drivers/scsi/sd.c
+++ b/drivers/scsi/sd.c
@@ -1012,7 +1012,8 @@
} else if (rq_data_dir(rq) == READ) {
SCpnt->cmnd[0] = READ_6;
} else {
- scmd_printk(KERN_ERR, SCpnt, "Unknown command %llx\n", (unsigned long long) rq->cmd_flags);
+ scmd_printk(KERN_ERR, SCpnt, "Unknown command %d,%llx\n",
+ req_op(rq), (unsigned long long) rq->cmd_flags);
goto out;
}
@@ -1137,21 +1138,27 @@
{
struct request *rq = cmd->request;
- if (rq->cmd_flags & REQ_DISCARD)
+ switch (req_op(rq)) {
+ case REQ_OP_DISCARD:
return sd_setup_discard_cmnd(cmd);
- else if (rq->cmd_flags & REQ_WRITE_SAME)
+ case REQ_OP_WRITE_SAME:
return sd_setup_write_same_cmnd(cmd);
- else if (rq->cmd_flags & REQ_FLUSH)
- return sd_setup_flush_cmnd(cmd);
- else
- return sd_setup_read_write_cmnd(cmd);
+ case REQ_OP_READ:
+ case REQ_OP_WRITE:
+ if (rq->cmd_flags & REQ_FLUSH)
+ return sd_setup_flush_cmnd(cmd);
+ else
+ return sd_setup_read_write_cmnd(cmd);
+ default:
+ BUG();
+ }
}
static void sd_uninit_command(struct scsi_cmnd *SCpnt)
{
struct request *rq = SCpnt->request;
- if (rq->cmd_flags & REQ_DISCARD)
+ if (req_op(rq) == REQ_OP_DISCARD)
__free_page(rq->completion_data);
if (SCpnt->cmnd != rq->cmd) {
@@ -1774,7 +1781,7 @@
unsigned char op = SCpnt->cmnd[0];
unsigned char unmap = SCpnt->cmnd[1] & 8;
- if (req->cmd_flags & REQ_DISCARD || req->cmd_flags & REQ_WRITE_SAME) {
+ if (req_op(req) == REQ_OP_DISCARD || req_op(req) == REQ_OP_WRITE_SAME) {
if (!result) {
good_bytes = blk_rq_bytes(req);
scsi_set_resid(SCpnt, 0);