[SCSI] qla4xxx: Updated firmware ready timeout algorithm
Updated firmware ready timeout algorithm to prevent
long delays and use jiffies to time out instead of
counter. Also use msleep_interruptible instead of msleep.
Signed-off-by: Karen Higgins <karen.higgins@qlogic.com>
Signed-off-by: Vikas Chaudhary <vikas.chaudhary@qlogic.com>
Signed-off-by: Ravi Anand <ravi.anand@qlogic.com>
Reviewed-by: Mike Christie <michaelc@cs.wisc.edu>
Signed-off-by: James Bottomley <James.Bottomley@suse.de>
diff --git a/drivers/scsi/qla4xxx/ql4_init.c b/drivers/scsi/qla4xxx/ql4_init.c
index 7f6cc2e..beaeb18 100644
--- a/drivers/scsi/qla4xxx/ql4_init.c
+++ b/drivers/scsi/qla4xxx/ql4_init.c
@@ -1046,7 +1046,7 @@
static int qla4xxx_start_firmware_from_flash(struct scsi_qla_host *ha)
{
int status = QLA_ERROR;
- uint32_t max_wait_time;
+ unsigned long max_wait_time;
unsigned long flags;
uint32_t mbox_status;
@@ -1078,7 +1078,10 @@
spin_unlock_irqrestore(&ha->hardware_lock, flags);
/* Wait for firmware to come UP. */
- max_wait_time = FIRMWARE_UP_TOV * 4;
+ DEBUG2(printk(KERN_INFO "scsi%ld: %s: Wait up to %d seconds for "
+ "boot firmware to complete...\n",
+ ha->host_no, __func__, FIRMWARE_UP_TOV));
+ max_wait_time = jiffies + (FIRMWARE_UP_TOV * HZ);
do {
uint32_t ctrl_status;
@@ -1092,16 +1095,15 @@
if (mbox_status == MBOX_STS_COMMAND_COMPLETE)
break;
- DEBUG2(printk("scsi%ld: %s: Waiting for boot firmware to "
- "complete... ctrl_sts=0x%x, remaining=%d\n",
- ha->host_no, __func__, ctrl_status,
- max_wait_time));
+ DEBUG2(printk(KERN_INFO "scsi%ld: %s: Waiting for boot "
+ "firmware to complete... ctrl_sts=0x%x\n",
+ ha->host_no, __func__, ctrl_status));
- msleep(250);
- } while ((max_wait_time--));
+ msleep_interruptible(250);
+ } while (!time_after_eq(jiffies, max_wait_time));
if (mbox_status == MBOX_STS_COMMAND_COMPLETE) {
- DEBUG(printk("scsi%ld: %s: Firmware has started\n",
+ DEBUG(printk(KERN_INFO "scsi%ld: %s: Firmware has started\n",
ha->host_no, __func__));
spin_lock_irqsave(&ha->hardware_lock, flags);