8390 : Replace ei_debug with msg_enable/NETIF_MSG_* feature
Removed the shared ei_debug variable. Replaced it by adding u32 msg_enable to
the private struct ei_device. Now each 8390 ethernet instance has a per-device
logging variable.
Changed older style printk() calls to more canonical forms.
Tested on: ne, ne2k-pci, smc-ultra, and wd hardware.
V4.0
- Substituted pr_info() and pr_debug() for printk() KERN_INFO and KERN_DEBUG
V3.0
- Checked for cases where pr_cont() was most appropriate choice.
- Changed module parameter from 'debug' to 'msg_enable' because debug was
no longer the best description.
V2.0
- Changed netif_msg_(drv|probe|ifdown|rx_err|tx_err|tx_queued|intr|rx_status|hw)
to netif_(dbg|info|warn|err) where possible.
Signed-off-by: Matthew Whitehead <tedheadster@gmail.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/ethernet/8390/apne.c b/drivers/net/ethernet/8390/apne.c
index 912ed7a..811fa5d 100644
--- a/drivers/net/ethernet/8390/apne.c
+++ b/drivers/net/ethernet/8390/apne.c
@@ -116,9 +116,15 @@
static int apne_owned; /* signal if card already owned */
+static u32 apne_msg_enable;
+module_param_named(msg_enable, apne_msg_enable, uint, (S_IRUSR|S_IRGRP|S_IROTH));
+MODULE_PARM_DESC(msg_enable, "Debug message level (see linux/netdevice.h for bitmap)");
+
struct net_device * __init apne_probe(int unit)
{
struct net_device *dev;
+ struct ei_device *ei_local;
+
#ifndef MANUAL_CONFIG
char tuple[8];
#endif
@@ -133,11 +139,11 @@
if ( !(AMIGAHW_PRESENT(PCMCIA)) )
return ERR_PTR(-ENODEV);
- printk("Looking for PCMCIA ethernet card : ");
+ pr_info("Looking for PCMCIA ethernet card : ");
/* check if a card is inserted */
if (!(PCMCIA_INSERTED)) {
- printk("NO PCMCIA card inserted\n");
+ pr_cont("NO PCMCIA card inserted\n");
return ERR_PTR(-ENODEV);
}
@@ -148,6 +154,8 @@
sprintf(dev->name, "eth%d", unit);
netdev_boot_setup_check(dev);
}
+ ei_local = netdev_priv(dev);
+ ei_local->msg_enable = apne_msg_enable;
/* disable pcmcia irq for readtuple */
pcmcia_disable_irq();
@@ -155,14 +163,14 @@
#ifndef MANUAL_CONFIG
if ((pcmcia_copy_tuple(CISTPL_FUNCID, tuple, 8) < 3) ||
(tuple[2] != CISTPL_FUNCID_NETWORK)) {
- printk("not an ethernet card\n");
+ pr_cont("not an ethernet card\n");
/* XXX: shouldn't we re-enable irq here? */
free_netdev(dev);
return ERR_PTR(-ENODEV);
}
#endif
- printk("ethernet PCMCIA card inserted\n");
+ pr_cont("ethernet PCMCIA card inserted\n");
if (!init_pcmcia()) {
/* XXX: shouldn't we re-enable irq here? */
@@ -204,11 +212,12 @@
int neX000, ctron;
#endif
static unsigned version_printed;
+ struct ei_device *ei_local = netdev_priv(dev);
- if (ei_debug && version_printed++ == 0)
- printk(version);
+ if ((apne_msg_enable & NETIF_MSG_DRV) && (version_printed++ == 0))
+ netdev_info(dev, version);
- printk("PCMCIA NE*000 ethercard probe");
+ netdev_info(dev, "PCMCIA NE*000 ethercard probe");
/* Reset card. Who knows what dain-bramaged state it was left in. */
{ unsigned long reset_start_time = jiffies;
@@ -217,7 +226,7 @@
while ((inb(ioaddr + NE_EN0_ISR) & ENISR_RESET) == 0)
if (time_after(jiffies, reset_start_time + 2*HZ/100)) {
- printk(" not found (no reset ack).\n");
+ pr_cont(" not found (no reset ack).\n");
return -ENODEV;
}
@@ -288,7 +297,7 @@
start_page = 0x01;
stop_page = (wordlength == 2) ? 0x40 : 0x20;
} else {
- printk(" not found.\n");
+ pr_cont(" not found.\n");
return -ENXIO;
}
@@ -320,9 +329,9 @@
for (i = 0; i < ETH_ALEN; i++)
dev->dev_addr[i] = SA_prom[i];
- printk(" %pM\n", dev->dev_addr);
+ pr_cont(" %pM\n", dev->dev_addr);
- printk("%s: %s found.\n", dev->name, name);
+ netdev_info(dev, "%s found.\n", name);
ei_status.name = name;
ei_status.tx_start_page = start_page;
@@ -352,10 +361,11 @@
apne_reset_8390(struct net_device *dev)
{
unsigned long reset_start_time = jiffies;
+ struct ei_device *ei_local = netdev_priv(dev);
init_pcmcia();
- if (ei_debug > 1) printk("resetting the 8390 t=%ld...", jiffies);
+ netif_dbg(ei_local, hw, dev, "resetting the 8390 t=%ld...\n", jiffies);
outb(inb(NE_BASE + NE_RESET), NE_BASE + NE_RESET);
@@ -365,8 +375,8 @@
/* This check _should_not_ be necessary, omit eventually. */
while ((inb(NE_BASE+NE_EN0_ISR) & ENISR_RESET) == 0)
if (time_after(jiffies, reset_start_time + 2*HZ/100)) {
- printk("%s: ne_reset_8390() did not complete.\n", dev->name);
- break;
+ netdev_err(dev, "ne_reset_8390() did not complete.\n");
+ break;
}
outb(ENISR_RESET, NE_BASE + NE_EN0_ISR); /* Ack intr. */
}
@@ -386,9 +396,9 @@
/* This *shouldn't* happen. If it does, it's the last thing you'll see */
if (ei_status.dmaing) {
- printk("%s: DMAing conflict in ne_get_8390_hdr "
- "[DMAstat:%d][irqlock:%d][intr:%d].\n",
- dev->name, ei_status.dmaing, ei_status.irqlock, dev->irq);
+ netdev_err(dev, "DMAing conflict in ne_get_8390_hdr "
+ "[DMAstat:%d][irqlock:%d][intr:%d].\n",
+ ei_status.dmaing, ei_status.irqlock, dev->irq);
return;
}
@@ -433,9 +443,9 @@
/* This *shouldn't* happen. If it does, it's the last thing you'll see */
if (ei_status.dmaing) {
- printk("%s: DMAing conflict in ne_block_input "
- "[DMAstat:%d][irqlock:%d][intr:%d].\n",
- dev->name, ei_status.dmaing, ei_status.irqlock, dev->irq);
+ netdev_err(dev, "DMAing conflict in ne_block_input "
+ "[DMAstat:%d][irqlock:%d][intr:%d].\n",
+ ei_status.dmaing, ei_status.irqlock, dev->irq);
return;
}
ei_status.dmaing |= 0x01;
@@ -481,9 +491,9 @@
/* This *shouldn't* happen. If it does, it's the last thing you'll see */
if (ei_status.dmaing) {
- printk("%s: DMAing conflict in ne_block_output."
- "[DMAstat:%d][irqlock:%d][intr:%d]\n",
- dev->name, ei_status.dmaing, ei_status.irqlock, dev->irq);
+ netdev_err(dev, "DMAing conflict in ne_block_output."
+ "[DMAstat:%d][irqlock:%d][intr:%d]\n",
+ ei_status.dmaing, ei_status.irqlock, dev->irq);
return;
}
ei_status.dmaing |= 0x01;
@@ -513,7 +523,7 @@
while ((inb(NE_BASE + NE_EN0_ISR) & ENISR_RDC) == 0)
if (time_after(jiffies, dma_start + 2*HZ/100)) { /* 20ms */
- printk("%s: timeout waiting for Tx RDC.\n", dev->name);
+ netdev_warn(dev, "timeout waiting for Tx RDC.\n");
apne_reset_8390(dev);
NS8390_init(dev,1);
break;
@@ -536,8 +546,8 @@
pcmcia_ack_int(pcmcia_intreq);
return IRQ_NONE;
}
- if (ei_debug > 3)
- printk("pcmcia intreq = %x\n", pcmcia_intreq);
+ if (apne_msg_enable & NETIF_MSG_INTR)
+ pr_debug("pcmcia intreq = %x\n", pcmcia_intreq);
pcmcia_disable_irq(); /* to get rid of the sti() within ei_interrupt */
ei_interrupt(irq, dev_id);
pcmcia_ack_int(pcmcia_get_intreq());