8390 : Replace ei_debug with msg_enable/NETIF_MSG_* feature
Removed the shared ei_debug variable. Replaced it by adding u32 msg_enable to
the private struct ei_device. Now each 8390 ethernet instance has a per-device
logging variable.
Changed older style printk() calls to more canonical forms.
Tested on: ne, ne2k-pci, smc-ultra, and wd hardware.
V4.0
- Substituted pr_info() and pr_debug() for printk() KERN_INFO and KERN_DEBUG
V3.0
- Checked for cases where pr_cont() was most appropriate choice.
- Changed module parameter from 'debug' to 'msg_enable' because debug was
no longer the best description.
V2.0
- Changed netif_msg_(drv|probe|ifdown|rx_err|tx_err|tx_queued|intr|rx_status|hw)
to netif_(dbg|info|warn|err) where possible.
Signed-off-by: Matthew Whitehead <tedheadster@gmail.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/ethernet/8390/pcnet_cs.c b/drivers/net/ethernet/8390/pcnet_cs.c
index 46c5aad..eea33d6 100644
--- a/drivers/net/ethernet/8390/pcnet_cs.c
+++ b/drivers/net/ethernet/8390/pcnet_cs.c
@@ -67,7 +67,7 @@
#define PCNET_RDC_TIMEOUT (2*HZ/100) /* Max wait in jiffies for Tx RDC */
static const char *if_names[] = { "auto", "10baseT", "10base2"};
-
+static u32 pcnet_msg_enable;
/*====================================================================*/
@@ -558,6 +558,7 @@
int start_pg, stop_pg, cm_offset;
int has_shmem = 0;
hw_info_t *local_hw_info;
+ struct ei_device *ei_local;
dev_dbg(&link->dev, "pcnet_config\n");
@@ -607,6 +608,8 @@
mii_phy_probe(dev);
SET_NETDEV_DEV(dev, &link->dev);
+ ei_local = netdev_priv(dev);
+ ei_local->msg_enable = pcnet_msg_enable;
if (register_netdev(dev) != 0) {
pr_notice("register_netdev() failed\n");
@@ -616,7 +619,7 @@
if (info->flags & (IS_DL10019|IS_DL10022)) {
u_char id = inb(dev->base_addr + 0x1a);
netdev_info(dev, "NE2000 (DL100%d rev %02x): ",
- (info->flags & IS_DL10022) ? 22 : 19, id);
+ (info->flags & IS_DL10022) ? 22 : 19, id);
if (info->pna_phy)
pr_cont("PNA, ");
} else {
@@ -1063,9 +1066,9 @@
if (info->phy_id == info->eth_phy) {
if (p)
netdev_info(dev, "autonegotiation complete: "
- "%sbaseT-%cD selected\n",
- ((p & 0x0180) ? "100" : "10"),
- ((p & 0x0140) ? 'F' : 'H'));
+ "%sbaseT-%cD selected\n",
+ ((p & 0x0180) ? "100" : "10"),
+ ((p & 0x0140) ? 'F' : 'H'));
else
netdev_info(dev, "link partner did not autonegotiate\n");
}
@@ -1081,7 +1084,7 @@
mdio_write(mii_addr, info->phy_id, 0, 0x0400);
info->phy_id ^= info->pna_phy ^ info->eth_phy;
netdev_info(dev, "switched to %s transceiver\n",
- (info->phy_id == info->eth_phy) ? "ethernet" : "PNA");
+ (info->phy_id == info->eth_phy) ? "ethernet" : "PNA");
mdio_write(mii_addr, info->phy_id, 0,
(info->phy_id == info->eth_phy) ? 0x1000 : 0);
info->link_status = 0;
@@ -1128,9 +1131,9 @@
unsigned int nic_base = dev->base_addr;
if (ei_status.dmaing) {
- netdev_notice(dev, "DMAing conflict in dma_block_input."
- "[DMAstat:%1x][irqlock:%1x]\n",
- ei_status.dmaing, ei_status.irqlock);
+ netdev_err(dev, "DMAing conflict in dma_block_input."
+ "[DMAstat:%1x][irqlock:%1x]\n",
+ ei_status.dmaing, ei_status.irqlock);
return;
}
@@ -1159,13 +1162,14 @@
unsigned int nic_base = dev->base_addr;
int xfer_count = count;
char *buf = skb->data;
+ struct ei_device *ei_local = netdev_priv(dev);
- if ((ei_debug > 4) && (count != 4))
+ if ((netif_msg_rx_status(ei_local)) && (count != 4))
netdev_dbg(dev, "[bi=%d]\n", count+4);
if (ei_status.dmaing) {
- netdev_notice(dev, "DMAing conflict in dma_block_input."
- "[DMAstat:%1x][irqlock:%1x]\n",
- ei_status.dmaing, ei_status.irqlock);
+ netdev_err(dev, "DMAing conflict in dma_block_input."
+ "[DMAstat:%1x][irqlock:%1x]\n",
+ ei_status.dmaing, ei_status.irqlock);
return;
}
ei_status.dmaing |= 0x01;
@@ -1183,7 +1187,8 @@
/* This was for the ALPHA version only, but enough people have been
encountering problems that it is still here. */
#ifdef PCMCIA_DEBUG
- if (ei_debug > 4) { /* DMA termination address check... */
+ /* DMA termination address check... */
+ if (netif_msg_rx_status(ei_local)) {
int addr, tries = 20;
do {
/* DON'T check for 'inb_p(EN0_ISR) & ENISR_RDC' here
@@ -1196,8 +1201,8 @@
} while (--tries > 0);
if (tries <= 0)
netdev_notice(dev, "RX transfer address mismatch,"
- "%#4.4x (expected) vs. %#4.4x (actual).\n",
- ring_offset + xfer_count, addr);
+ "%#4.4x (expected) vs. %#4.4x (actual).\n",
+ ring_offset + xfer_count, addr);
}
#endif
outb_p(ENISR_RDC, nic_base + EN0_ISR); /* Ack intr. */
@@ -1213,12 +1218,12 @@
pcnet_dev_t *info = PRIV(dev);
#ifdef PCMCIA_DEBUG
int retries = 0;
+ struct ei_device *ei_local = netdev_priv(dev);
#endif
u_long dma_start;
#ifdef PCMCIA_DEBUG
- if (ei_debug > 4)
- netdev_dbg(dev, "[bo=%d]\n", count);
+ netif_dbg(ei_local, tx_queued, dev, "[bo=%d]\n", count);
#endif
/* Round the count up for word writes. Do we need to do this?
@@ -1227,9 +1232,9 @@
if (count & 0x01)
count++;
if (ei_status.dmaing) {
- netdev_notice(dev, "DMAing conflict in dma_block_output."
- "[DMAstat:%1x][irqlock:%1x]\n",
- ei_status.dmaing, ei_status.irqlock);
+ netdev_err(dev, "DMAing conflict in dma_block_output."
+ "[DMAstat:%1x][irqlock:%1x]\n",
+ ei_status.dmaing, ei_status.irqlock);
return;
}
ei_status.dmaing |= 0x01;
@@ -1256,7 +1261,8 @@
#ifdef PCMCIA_DEBUG
/* This was for the ALPHA version only, but enough people have been
encountering problems that it is still here. */
- if (ei_debug > 4) { /* DMA termination address check... */
+ /* DMA termination address check... */
+ if (netif_msg_tx_queued(ei_local)) {
int addr, tries = 20;
do {
int high = inb_p(nic_base + EN0_RSARHI);
@@ -1267,8 +1273,8 @@
} while (--tries > 0);
if (tries <= 0) {
netdev_notice(dev, "Tx packet transfer address mismatch,"
- "%#4.4x (expected) vs. %#4.4x (actual).\n",
- (start_page << 8) + count, addr);
+ "%#4.4x (expected) vs. %#4.4x (actual).\n",
+ (start_page << 8) + count, addr);
if (retries++ == 0)
goto retry;
}
@@ -1277,10 +1283,10 @@
while ((inb_p(nic_base + EN0_ISR) & ENISR_RDC) == 0)
if (time_after(jiffies, dma_start + PCNET_RDC_TIMEOUT)) {
- netdev_notice(dev, "timeout waiting for Tx RDC.\n");
- pcnet_reset_8390(dev);
- NS8390_init(dev, 1);
- break;
+ netdev_warn(dev, "timeout waiting for Tx RDC.\n");
+ pcnet_reset_8390(dev);
+ NS8390_init(dev, 1);
+ break;
}
outb_p(ENISR_RDC, nic_base + EN0_ISR); /* Ack intr. */