cpufreq: governor: Fix typos in comments
- 'Governer' should be 'Governor'.
- 'S' is used for Siemens (electrical conductance) in SI units,
so use small 's' for seconds.
Signed-off-by: Stratos Karafotis <stratosk@semaphore.gr>
Acked-by: Viresh Kumar <viresh.kumar@linaro.org>
Signed-off-by: Rafael J. Wysocki <rafael.j.wysocki@intel.com>
diff --git a/drivers/cpufreq/cpufreq_governor.h b/drivers/cpufreq/cpufreq_governor.h
index a02d78b..88cd39f 100644
--- a/drivers/cpufreq/cpufreq_governor.h
+++ b/drivers/cpufreq/cpufreq_governor.h
@@ -25,11 +25,11 @@
/*
* The polling frequency depends on the capability of the processor. Default
* polling frequency is 1000 times the transition latency of the processor. The
- * governor will work on any processor with transition latency <= 10mS, using
+ * governor will work on any processor with transition latency <= 10ms, using
* appropriate sampling rate.
*
- * For CPUs with transition latency > 10mS (mostly drivers with CPUFREQ_ETERNAL)
- * this governor will not work. All times here are in uS.
+ * For CPUs with transition latency > 10ms (mostly drivers with CPUFREQ_ETERNAL)
+ * this governor will not work. All times here are in us (micro seconds).
*/
#define MIN_SAMPLING_RATE_RATIO (2)
#define LATENCY_MULTIPLIER (1000)
@@ -162,7 +162,7 @@
unsigned int enable:1;
};
-/* Per policy Governers sysfs tunables */
+/* Per policy Governors sysfs tunables */
struct od_dbs_tuners {
unsigned int ignore_nice_load;
unsigned int sampling_rate;
@@ -181,7 +181,7 @@
unsigned int freq_step;
};
-/* Common Governer data across policies */
+/* Common Governor data across policies */
struct dbs_data;
struct common_dbs_data {
/* Common across governors */
@@ -205,7 +205,7 @@
void *gov_ops;
};
-/* Governer Per policy data */
+/* Governor Per policy data */
struct dbs_data {
struct common_dbs_data *cdata;
unsigned int min_sampling_rate;