drm: try to restore previous CRTC config if mode set fails
We restore the CRTC, encoder, and connector configurations, but if the
mode set failed, the attached display may have been turned off, so we
need to try set_config again to restore things to the way they were.
Signed-off-by: Jesse Barnes <jbarnes@virtuousgeek.org>
Reviewed-by: Alex Deucher <alexdeucher@gmail.com>
Signed-off-by: Dave Airlie <airlied@redhat.com>
diff --git a/drivers/gpu/drm/drm_crtc_helper.c b/drivers/gpu/drm/drm_crtc_helper.c
index 2957636..3969f75 100644
--- a/drivers/gpu/drm/drm_crtc_helper.c
+++ b/drivers/gpu/drm/drm_crtc_helper.c
@@ -484,6 +484,7 @@
struct drm_connector *save_connectors, *connector;
int count = 0, ro, fail = 0;
struct drm_crtc_helper_funcs *crtc_funcs;
+ struct drm_mode_set save_set;
int ret = 0;
int i;
@@ -556,6 +557,12 @@
save_connectors[count++] = *connector;
}
+ save_set.crtc = set->crtc;
+ save_set.mode = &set->crtc->mode;
+ save_set.x = set->crtc->x;
+ save_set.y = set->crtc->y;
+ save_set.fb = set->crtc->fb;
+
/* We should be able to check here if the fb has the same properties
* and then just flip_or_move it */
if (set->crtc->fb != set->fb) {
@@ -721,6 +728,12 @@
*connector = save_connectors[count++];
}
+ /* Try to restore the config */
+ if (mode_changed &&
+ !drm_crtc_helper_set_mode(save_set.crtc, save_set.mode, save_set.x,
+ save_set.y, save_set.fb))
+ DRM_ERROR("failed to restore config after modeset failure\n");
+
kfree(save_connectors);
kfree(save_encoders);
kfree(save_crtcs);