ath10k: implement rx reorder support
New firmware and firmware (qca6174 hw3.0+ and fw
266+) are capable of full aggregation rx
reordering. If it's enabled then Rx is handled via
a new, separate htt event.
The rx ring behaviour is changed a little to
support the new rx scheme. These changes shouldn't
affect qca988x performance.
Signed-off-by: Michal Kazior <michal.kazior@tieto.com>
Signed-off-by: Kalle Valo <kvalo@qca.qualcomm.com>
diff --git a/drivers/net/wireless/ath/ath10k/core.c b/drivers/net/wireless/ath/ath10k/core.c
index a546575..6860afb 100644
--- a/drivers/net/wireless/ath/ath10k/core.c
+++ b/drivers/net/wireless/ath/ath10k/core.c
@@ -1061,6 +1061,18 @@
goto err_hif_stop;
}
+ /* If firmware indicates Full Rx Reorder support it must be used in a
+ * slightly different manner. Let HTT code know.
+ */
+ ar->htt.rx_ring.in_ord_rx = !!(test_bit(WMI_SERVICE_RX_FULL_REORDER,
+ ar->wmi.svc_map));
+
+ status = ath10k_htt_rx_ring_refill(ar);
+ if (status) {
+ ath10k_err(ar, "failed to refill htt rx ring: %d\n", status);
+ goto err_hif_stop;
+ }
+
/* we don't care about HTT in UTF mode */
if (mode == ATH10K_FIRMWARE_MODE_NORMAL) {
status = ath10k_htt_setup(&ar->htt);