| /* ehci-msm.c - HSUSB Host Controller Driver Implementation |
| * |
| * Copyright (c) 2008-2011, Code Aurora Forum. All rights reserved. |
| * |
| * Partly derived from ehci-fsl.c and ehci-hcd.c |
| * Copyright (c) 2000-2004 by David Brownell |
| * Copyright (c) 2005 MontaVista Software |
| * |
| * All source code in this file is licensed under the following license except |
| * where indicated. |
| * |
| * This program is free software; you can redistribute it and/or modify it |
| * under the terms of the GNU General Public License version 2 as published |
| * by the Free Software Foundation. |
| * |
| * This program is distributed in the hope that it will be useful, |
| * but WITHOUT ANY WARRANTY; without even the implied warranty of |
| * MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. |
| * |
| * See the GNU General Public License for more details. |
| * You should have received a copy of the GNU General Public License |
| * along with this program; if not, you can find it at http://www.fsf.org |
| */ |
| |
| #include <linux/clk.h> |
| #include <linux/err.h> |
| #include <linux/io.h> |
| #include <linux/kernel.h> |
| #include <linux/module.h> |
| #include <linux/platform_device.h> |
| #include <linux/pm_runtime.h> |
| #include <linux/usb/otg.h> |
| #include <linux/usb/msm_hsusb_hw.h> |
| #include <linux/usb.h> |
| #include <linux/usb/hcd.h> |
| #include <linux/acpi.h> |
| |
| #include "ehci.h" |
| |
| #define MSM_USB_BASE (hcd->regs) |
| |
| #define DRIVER_DESC "Qualcomm On-Chip EHCI Host Controller" |
| |
| static const char hcd_name[] = "ehci-msm"; |
| static struct hc_driver __read_mostly msm_hc_driver; |
| |
| static int ehci_msm_reset(struct usb_hcd *hcd) |
| { |
| struct ehci_hcd *ehci = hcd_to_ehci(hcd); |
| int retval; |
| |
| ehci->caps = USB_CAPLENGTH; |
| hcd->has_tt = 1; |
| |
| retval = ehci_setup(hcd); |
| if (retval) |
| return retval; |
| |
| /* select ULPI phy and clear other status/control bits in PORTSC */ |
| writel(PORTSC_PTS_ULPI, USB_PORTSC); |
| /* bursts of unspecified length. */ |
| writel(0, USB_AHBBURST); |
| /* Use the AHB transactor, allow posted data writes */ |
| writel(0x8, USB_AHBMODE); |
| /* Disable streaming mode and select host mode */ |
| writel(0x13, USB_USBMODE); |
| /* Disable ULPI_TX_PKT_EN_CLR_FIX which is valid only for HSIC */ |
| writel(readl(USB_GENCONFIG_2) & ~ULPI_TX_PKT_EN_CLR_FIX, USB_GENCONFIG_2); |
| |
| return 0; |
| } |
| |
| static int ehci_msm_probe(struct platform_device *pdev) |
| { |
| struct usb_hcd *hcd; |
| struct resource *res; |
| struct usb_phy *phy; |
| int ret; |
| |
| dev_dbg(&pdev->dev, "ehci_msm proble\n"); |
| |
| hcd = usb_create_hcd(&msm_hc_driver, &pdev->dev, dev_name(&pdev->dev)); |
| if (!hcd) { |
| dev_err(&pdev->dev, "Unable to create HCD\n"); |
| return -ENOMEM; |
| } |
| |
| ret = platform_get_irq(pdev, 0); |
| if (ret < 0) { |
| dev_err(&pdev->dev, "Unable to get IRQ resource\n"); |
| goto put_hcd; |
| } |
| hcd->irq = ret; |
| |
| res = platform_get_resource(pdev, IORESOURCE_MEM, 0); |
| if (!res) { |
| dev_err(&pdev->dev, "Unable to get memory resource\n"); |
| ret = -ENODEV; |
| goto put_hcd; |
| } |
| |
| hcd->rsrc_start = res->start; |
| hcd->rsrc_len = resource_size(res); |
| hcd->regs = devm_ioremap(&pdev->dev, hcd->rsrc_start, hcd->rsrc_len); |
| if (!hcd->regs) { |
| dev_err(&pdev->dev, "ioremap failed\n"); |
| ret = -ENOMEM; |
| goto put_hcd; |
| } |
| |
| /* |
| * If there is an OTG driver, let it take care of PHY initialization, |
| * clock management, powering up VBUS, mapping of registers address |
| * space and power management. |
| */ |
| if (pdev->dev.of_node) |
| phy = devm_usb_get_phy_by_phandle(&pdev->dev, "usb-phy", 0); |
| else |
| phy = devm_usb_get_phy(&pdev->dev, USB_PHY_TYPE_USB2); |
| |
| if (IS_ERR(phy)) { |
| if (PTR_ERR(phy) == -EPROBE_DEFER) { |
| dev_err(&pdev->dev, "unable to find transceiver\n"); |
| ret = -EPROBE_DEFER; |
| goto put_hcd; |
| } |
| phy = NULL; |
| } |
| |
| hcd->usb_phy = phy; |
| device_init_wakeup(&pdev->dev, 1); |
| |
| if (phy && phy->otg) { |
| /* |
| * MSM OTG driver takes care of adding the HCD and |
| * placing hardware into low power mode via runtime PM. |
| */ |
| ret = otg_set_host(phy->otg, &hcd->self); |
| if (ret < 0) { |
| dev_err(&pdev->dev, "unable to register with transceiver\n"); |
| goto put_hcd; |
| } |
| |
| pm_runtime_no_callbacks(&pdev->dev); |
| pm_runtime_enable(&pdev->dev); |
| } else { |
| ret = usb_add_hcd(hcd, hcd->irq, IRQF_SHARED); |
| if (ret) |
| goto put_hcd; |
| } |
| |
| return 0; |
| |
| put_hcd: |
| usb_put_hcd(hcd); |
| |
| return ret; |
| } |
| |
| static int ehci_msm_remove(struct platform_device *pdev) |
| { |
| struct usb_hcd *hcd = platform_get_drvdata(pdev); |
| |
| device_init_wakeup(&pdev->dev, 0); |
| pm_runtime_disable(&pdev->dev); |
| pm_runtime_set_suspended(&pdev->dev); |
| |
| if (hcd->usb_phy && hcd->usb_phy->otg) |
| otg_set_host(hcd->usb_phy->otg, NULL); |
| else |
| usb_remove_hcd(hcd); |
| |
| usb_put_hcd(hcd); |
| |
| return 0; |
| } |
| |
| #ifdef CONFIG_PM |
| static int ehci_msm_pm_suspend(struct device *dev) |
| { |
| struct usb_hcd *hcd = dev_get_drvdata(dev); |
| bool do_wakeup = device_may_wakeup(dev); |
| |
| dev_dbg(dev, "ehci-msm PM suspend\n"); |
| |
| return ehci_suspend(hcd, do_wakeup); |
| } |
| |
| static int ehci_msm_pm_resume(struct device *dev) |
| { |
| struct usb_hcd *hcd = dev_get_drvdata(dev); |
| |
| dev_dbg(dev, "ehci-msm PM resume\n"); |
| ehci_resume(hcd, false); |
| |
| return 0; |
| } |
| #else |
| #define ehci_msm_pm_suspend NULL |
| #define ehci_msm_pm_resume NULL |
| #endif |
| |
| static const struct dev_pm_ops ehci_msm_dev_pm_ops = { |
| .suspend = ehci_msm_pm_suspend, |
| .resume = ehci_msm_pm_resume, |
| }; |
| |
| static const struct acpi_device_id msm_ehci_acpi_ids[] = { |
| { "QCOM8040", 0 }, |
| { } |
| }; |
| MODULE_DEVICE_TABLE(acpi, msm_ehci_acpi_ids); |
| |
| static const struct of_device_id msm_ehci_dt_match[] = { |
| { .compatible = "qcom,ehci-host", }, |
| {} |
| }; |
| MODULE_DEVICE_TABLE(of, msm_ehci_dt_match); |
| |
| static struct platform_driver ehci_msm_driver = { |
| .probe = ehci_msm_probe, |
| .remove = ehci_msm_remove, |
| .shutdown = usb_hcd_platform_shutdown, |
| .driver = { |
| .name = "msm_hsusb_host", |
| .pm = &ehci_msm_dev_pm_ops, |
| .of_match_table = msm_ehci_dt_match, |
| .acpi_match_table = ACPI_PTR(msm_ehci_acpi_ids), |
| }, |
| }; |
| |
| static const struct ehci_driver_overrides msm_overrides __initconst = { |
| .reset = ehci_msm_reset, |
| }; |
| |
| static int __init ehci_msm_init(void) |
| { |
| if (usb_disabled()) |
| return -ENODEV; |
| |
| pr_info("%s: " DRIVER_DESC "\n", hcd_name); |
| ehci_init_driver(&msm_hc_driver, &msm_overrides); |
| return platform_driver_register(&ehci_msm_driver); |
| } |
| module_init(ehci_msm_init); |
| |
| static void __exit ehci_msm_cleanup(void) |
| { |
| platform_driver_unregister(&ehci_msm_driver); |
| } |
| module_exit(ehci_msm_cleanup); |
| |
| MODULE_DESCRIPTION(DRIVER_DESC); |
| MODULE_ALIAS("platform:msm-ehci"); |
| MODULE_LICENSE("GPL"); |