ath9k: Fix calibration for AR9462
TX IQ calibration is disabled by default for AR9462, this
is done using the initvals (reg 0xa644).
But, to compensate for this, the AR_PHY_RX_DELAY register
should be set to the max allowed value when performing
calibration.
Signed-off-by: Sujith Manoharan <c_manoha@qca.qualcomm.com>
Signed-off-by: John W. Linville <linville@tuxdriver.com>
diff --git a/drivers/net/wireless/ath/ath9k/ar9003_calib.c b/drivers/net/wireless/ath/ath9k/ar9003_calib.c
index 6988e1d..6001bc0 100644
--- a/drivers/net/wireless/ath/ath9k/ar9003_calib.c
+++ b/drivers/net/wireless/ath/ath9k/ar9003_calib.c
@@ -1019,6 +1019,7 @@
bool is_reusable = true, status = true;
bool run_rtt_cal = false, run_agc_cal, sep_iq_cal = false;
bool rtt = !!(ah->caps.hw_caps & ATH9K_HW_CAP_RTT);
+ u32 rx_delay = 0;
u32 agc_ctrl = 0, agc_supp_cals = AR_PHY_AGC_CONTROL_OFFSET_CAL |
AR_PHY_AGC_CONTROL_FLTR_CAL |
AR_PHY_AGC_CONTROL_PKDET_CAL;
@@ -1099,6 +1100,15 @@
REG_WRITE(ah, AR_PHY_ACTIVE, AR_PHY_ACTIVE_EN);
}
+ if (REG_READ(ah, AR_PHY_CL_CAL_CTL) & AR_PHY_CL_CAL_ENABLE) {
+ rx_delay = REG_READ(ah, AR_PHY_RX_DELAY);
+ /* Disable BB_active */
+ REG_WRITE(ah, AR_PHY_ACTIVE, AR_PHY_ACTIVE_DIS);
+ udelay(5);
+ REG_WRITE(ah, AR_PHY_RX_DELAY, AR_PHY_RX_DELAY_DELAY);
+ REG_WRITE(ah, AR_PHY_ACTIVE, AR_PHY_ACTIVE_EN);
+ }
+
if (run_agc_cal || !(ah->ah_flags & AH_FASTCC)) {
/* Calibrate the AGC */
REG_WRITE(ah, AR_PHY_AGC_CONTROL,
@@ -1113,6 +1123,11 @@
ar9003_hw_do_manual_peak_cal(ah, chan);
}
+ if (REG_READ(ah, AR_PHY_CL_CAL_CTL) & AR_PHY_CL_CAL_ENABLE) {
+ REG_WRITE(ah, AR_PHY_RX_DELAY, rx_delay);
+ udelay(5);
+ }
+
if (ath9k_hw_mci_is_enabled(ah) && IS_CHAN_2GHZ(chan) && run_agc_cal)
ar9003_mci_init_cal_done(ah);