CRIS: Fix RS485 delay handling.
Very recently, the RS485 interface has been fixed by adding two further
fields (see commit 1b6331848b69d1ed165a6bdc75c4046d68767563).
Check the value of the flag SER_RS485_RTS_BEFORE_SEND before delaying.
Signed-off-by: Claudio Scordino <claudio@evidence.eu.com>
Signed-off-by: Jesper Nilsson <jesper.nilsson@axis.com>
diff --git a/drivers/serial/crisv10.c b/drivers/serial/crisv10.c
index 20402c6..fa62578 100644
--- a/drivers/serial/crisv10.c
+++ b/drivers/serial/crisv10.c
@@ -1411,11 +1411,12 @@
CONFIG_ETRAX_RS485_LTC1387_RXEN_PORT_G_BIT, 1);
#endif
- info->rs485.flags = r->flags;
- if (r->delay_rts_before_send >= 1000)
+ info->rs485 = *r;
+
+ /* Maximum delay before RTS equal to 1000 */
+ if (info->rs485.delay_rts_before_send >= 1000)
info->rs485.delay_rts_before_send = 1000;
- else
- info->rs485.delay_rts_before_send = r->delay_rts_before_send;
+
/* printk("rts: on send = %i, after = %i, enabled = %i",
info->rs485.rts_on_send,
info->rs485.rts_after_sent,
@@ -3234,9 +3235,9 @@
e100_disable_rx(info);
e100_enable_rx_irq(info);
#endif
-
- if (info->rs485.delay_rts_before_send > 0)
- msleep(info->rs485.delay_rts_before_send);
+ if ((info->rs485.flags & SER_RS485_RTS_BEFORE_SEND) &&
+ (info->rs485.delay_rts_before_send > 0))
+ msleep(info->rs485.delay_rts_before_send);
}
#endif /* CONFIG_ETRAX_RS485 */
@@ -3694,6 +3695,11 @@
rs485data.delay_rts_before_send = rs485ctrl.delay_rts_before_send;
rs485data.flags = 0;
+ if (rs485data.delay_rts_before_send != 0)
+ rs485data.flags |= SER_RS485_RTS_BEFORE_SEND;
+ else
+ rs485data.flags &= ~(SER_RS485_RTS_BEFORE_SEND);
+
if (rs485ctrl.enabled)
rs485data.flags |= SER_RS485_ENABLED;
else
@@ -4527,6 +4533,7 @@
/* Set sane defaults */
info->rs485.flags &= ~(SER_RS485_RTS_ON_SEND);
info->rs485.flags |= SER_RS485_RTS_AFTER_SEND;
+ info->rs485.flags &= ~(SER_RS485_RTS_BEFORE_SEND);
info->rs485.delay_rts_before_send = 0;
info->rs485.flags &= ~(SER_RS485_ENABLED);
#endif