Input: edt-ft5x06 - use max support points to determine how much to read
Calculate the amount of data that needs to be read for the specified max
number of support points. If the maximum number of support points changes
then the amount that is read from the touch screen controller should
reflect this.
Signed-off-by: Franklin S Cooper Jr <fcooper@ti.com>
Signed-off-by: Dmitry Torokhov <dmitry.torokhov@gmail.com>
diff --git a/drivers/input/touchscreen/edt-ft5x06.c b/drivers/input/touchscreen/edt-ft5x06.c
index a8640c7..a76bc48 100644
--- a/drivers/input/touchscreen/edt-ft5x06.c
+++ b/drivers/input/touchscreen/edt-ft5x06.c
@@ -168,9 +168,9 @@
struct edt_ft5x06_ts_data *tsdata = dev_id;
struct device *dev = &tsdata->client->dev;
u8 cmd;
- u8 rdbuf[29];
+ u8 rdbuf[31];
int i, type, x, y, id;
- int offset, tplen, datalen;
+ int offset, tplen, datalen, crclen;
int error;
switch (tsdata->version) {
@@ -178,14 +178,14 @@
cmd = 0xf9; /* tell the controller to send touch data */
offset = 5; /* where the actual touch data starts */
tplen = 4; /* data comes in so called frames */
- datalen = 26; /* how much bytes to listen for */
+ crclen = 1; /* length of the crc data */
break;
case M09:
cmd = 0x02;
offset = 1;
tplen = 6;
- datalen = 29;
+ crclen = 0;
break;
default:
@@ -193,6 +193,7 @@
}
memset(rdbuf, 0, sizeof(rdbuf));
+ datalen = tplen * MAX_SUPPORT_POINTS + offset + crclen;
error = edt_ft5x06_ts_readwrite(tsdata->client,
sizeof(cmd), &cmd,