USB: belkin_sa.c: remove dbg() usage
dbg() is a usb-serial specific macro. This patch converts
the belkin_sa.c driver to use dev_dbg() instead to tie into the
dynamic debug infrastructure.
CC: William Greathouse <wgreathouse@smva.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
diff --git a/drivers/usb/serial/belkin_sa.c b/drivers/usb/serial/belkin_sa.c
index 5965df7..6b73656 100644
--- a/drivers/usb/serial/belkin_sa.c
+++ b/drivers/usb/serial/belkin_sa.c
@@ -197,12 +197,12 @@
case -ENOENT:
case -ESHUTDOWN:
/* this urb is terminated, clean up */
- dbg("%s - urb shutting down with status: %d",
- __func__, status);
+ dev_dbg(&port->dev, "%s - urb shutting down with status: %d\n",
+ __func__, status);
return;
default:
- dbg("%s - nonzero urb status received: %d",
- __func__, status);
+ dev_dbg(&port->dev, "%s - nonzero urb status received: %d\n",
+ __func__, status);
goto exit;
}
@@ -391,7 +391,8 @@
urb_value = BELKIN_SA_DATA_BITS(8);
break;
default:
- dbg("CSIZE was not CS5-CS8, using default of 8");
+ dev_dbg(&port->dev,
+ "CSIZE was not CS5-CS8, using default of 8\n");
urb_value = BELKIN_SA_DATA_BITS(8);
break;
}