wlcore: suppress error message on Rx BA session removal
The ampdu_action() function is called on the reconfig() path to remove
existing Rx BA sessions. Since these don't exist for the low level
driver, we output an error message. Turn the message into a debug
message for now, until the mac80211 reconfig flow is changed.
Signed-off-by: Arik Nemtsov <arik@wizery.com>
Signed-off-by: Luciano Coelho <coelho@ti.com>
diff --git a/drivers/net/wireless/ti/wlcore/main.c b/drivers/net/wireless/ti/wlcore/main.c
index 8eefcd7..22b342f 100644
--- a/drivers/net/wireless/ti/wlcore/main.c
+++ b/drivers/net/wireless/ti/wlcore/main.c
@@ -4366,9 +4366,14 @@
case IEEE80211_AMPDU_RX_STOP:
if (!(*ba_bitmap & BIT(tid))) {
- ret = -EINVAL;
- wl1271_error("no active RX BA session on tid: %d",
+ /*
+ * this happens on reconfig - so only output a debug
+ * message for now, and don't fail the function.
+ */
+ wl1271_debug(DEBUG_MAC80211,
+ "no active RX BA session on tid: %d",
tid);
+ ret = 0;
break;
}