i.MX IPU DMA: Fix wrong burstsize settings
The burstsize (npb in struct chan_param_mem) is set in
ipu_ch_param_set_size() once. The number of allowed
pixels in a burst depend on the pixel format and the
rotation mode. For 16bit formats 16 pixels are allowed
whereas for 32bit formats only 8 pixels are allowed.
Set these values correctly in ipu_ch_param_set_size()
and do not overwrite them afterwards.
We do not support rotation right now, so ignore this
case.
This patch fixes the wrong burstsize setting of 16 pixels
for 32bpp.
Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>
Signed-off-by: Vinod Koul <vinod.koul@linux.intel.com>
diff --git a/drivers/dma/ipu/ipu_idmac.c b/drivers/dma/ipu/ipu_idmac.c
index e16e280..6212b16 100644
--- a/drivers/dma/ipu/ipu_idmac.c
+++ b/drivers/dma/ipu/ipu_idmac.c
@@ -312,7 +312,7 @@
case IPU_PIX_FMT_RGB565:
params->ip.bpp = 2;
params->ip.pfs = 4;
- params->ip.npb = 7;
+ params->ip.npb = 15;
params->ip.sat = 2; /* SAT = 32-bit access */
params->ip.ofs0 = 0; /* Red bit offset */
params->ip.ofs1 = 5; /* Green bit offset */
@@ -422,12 +422,6 @@
params->pp.nsb = 1;
}
-static void ipu_ch_param_set_burst_size(union chan_param_mem *params,
- uint16_t burst_pixels)
-{
- params->pp.npb = burst_pixels - 1;
-}
-
static void ipu_ch_param_set_buffer(union chan_param_mem *params,
dma_addr_t buf0, dma_addr_t buf1)
{
@@ -690,23 +684,6 @@
ipu_ch_param_set_size(¶ms, pixel_fmt, width, height, stride_bytes);
ipu_ch_param_set_buffer(¶ms, phyaddr_0, phyaddr_1);
ipu_ch_param_set_rotation(¶ms, rot_mode);
- /* Some channels (rotation) have restriction on burst length */
- switch (channel) {
- case IDMAC_IC_7: /* Hangs with burst 8, 16, other values
- invalid - Table 44-30 */
-/*
- ipu_ch_param_set_burst_size(¶ms, 8);
- */
- break;
- case IDMAC_SDC_0:
- case IDMAC_SDC_1:
- /* In original code only IPU_PIX_FMT_RGB565 was setting burst */
- ipu_ch_param_set_burst_size(¶ms, 16);
- break;
- case IDMAC_IC_0:
- default:
- break;
- }
spin_lock_irqsave(&ipu->lock, flags);