gpio/pca953x: increase variables size to support 24 bit of data
Increase variable size from u16 to u32 to allocate 24 bit of data required for
the TCA6424 I/O expander device type.
Signed-off-by: Leed Aguilar <leed.aguilar@ti.com>
Signed-off-by: Chandrabhanu Mahapatra <cmahapatra@ti.com>
Signed-off-by: Linus Walleij <linus.walleij@linaro.org>
diff --git a/drivers/gpio/gpio-pca953x.c b/drivers/gpio/gpio-pca953x.c
index 266b910..9c693ae 100644
--- a/drivers/gpio/gpio-pca953x.c
+++ b/drivers/gpio/gpio-pca953x.c
@@ -78,10 +78,10 @@
#ifdef CONFIG_GPIO_PCA953X_IRQ
struct mutex irq_lock;
- uint16_t irq_mask;
- uint16_t irq_stat;
- uint16_t irq_trig_raise;
- uint16_t irq_trig_fall;
+ u32 irq_mask;
+ u32 irq_stat;
+ u32 irq_trig_raise;
+ u32 irq_trig_fall;
int irq_base;
#endif
@@ -353,8 +353,8 @@
static void pca953x_irq_bus_sync_unlock(struct irq_data *d)
{
struct pca953x_chip *chip = irq_data_get_irq_chip_data(d);
- uint16_t new_irqs;
- uint16_t level;
+ u32 new_irqs;
+ u32 level;
/* Look for any newly setup interrupt */
new_irqs = chip->irq_trig_fall | chip->irq_trig_raise;
@@ -372,8 +372,8 @@
static int pca953x_irq_set_type(struct irq_data *d, unsigned int type)
{
struct pca953x_chip *chip = irq_data_get_irq_chip_data(d);
- uint16_t level = d->irq - chip->irq_base;
- uint16_t mask = 1 << level;
+ u32 level = d->irq - chip->irq_base;
+ u32 mask = 1 << level;
if (!(type & IRQ_TYPE_EDGE_BOTH)) {
dev_err(&chip->client->dev, "irq %d: unsupported type %d\n",
@@ -403,12 +403,12 @@
.irq_set_type = pca953x_irq_set_type,
};
-static uint16_t pca953x_irq_pending(struct pca953x_chip *chip)
+static u32 pca953x_irq_pending(struct pca953x_chip *chip)
{
u32 cur_stat;
- uint16_t old_stat;
- uint16_t pending;
- uint16_t trigger;
+ u32 old_stat;
+ u32 pending;
+ u32 trigger;
int ret, offset = 0;
switch (chip->chip_type) {
@@ -444,8 +444,8 @@
static irqreturn_t pca953x_irq_handler(int irq, void *devid)
{
struct pca953x_chip *chip = devid;
- uint16_t pending;
- uint16_t level;
+ u32 pending;
+ u32 level;
pending = pca953x_irq_pending(chip);