netdev: convert at1700 to net_device_ops
Remove unneeded memset (alloc_etherdev does it already).
Signed-off-by: Stephen Hemminger <shemminger@vyatta.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/at1700.c b/drivers/net/at1700.c
index ced7079..18b566a 100644
--- a/drivers/net/at1700.c
+++ b/drivers/net/at1700.c
@@ -249,6 +249,17 @@
return ERR_PTR(err);
}
+static const struct net_device_ops at1700_netdev_ops = {
+ .ndo_open = net_open,
+ .ndo_stop = net_close,
+ .ndo_start_xmit = net_send_packet,
+ .ndo_set_multicast_list = set_rx_mode,
+ .ndo_tx_timeout = net_tx_timeout,
+ .ndo_change_mtu = eth_change_mtu,
+ .ndo_set_mac_address = eth_mac_addr,
+ .ndo_validate_addr = eth_validate_addr,
+};
+
/* The Fujitsu datasheet suggests that the NIC be probed for by checking its
"signature", the default bit pattern after a reset. This *doesn't* work --
there is no way to reset the bus interface without a complete power-cycle!
@@ -448,13 +459,7 @@
if (net_debug)
printk(version);
- memset(lp, 0, sizeof(struct net_local));
-
- dev->open = net_open;
- dev->stop = net_close;
- dev->hard_start_xmit = net_send_packet;
- dev->set_multicast_list = &set_rx_mode;
- dev->tx_timeout = net_tx_timeout;
+ dev->netdev_ops = &at1700_netdev_ops;
dev->watchdog_timeo = TX_TIMEOUT;
spin_lock_init(&lp->lock);