rt2x00: Allow tx duplication for legacy rates in HT40 mode
Make use of the IEEE80211_TX_RC_DUP_DATA flag to duplicate a
transmission with legacy rates to both 20Mhz channels if set.
Also update the related comment in rt2800.h to describe the
behavior of the BW_40 flag for legacy rates.
Signed-off-by: Helmut Schaa <helmut.schaa@googlemail.com>
Signed-off-by: Ivo van Doorn <IvDoorn@gmail.com>
Signed-off-by: John W. Linville <linville@tuxdriver.com>
diff --git a/drivers/net/wireless/rt2x00/rt2800.h b/drivers/net/wireless/rt2x00/rt2800.h
index e1583cf..9bf50a1 100644
--- a/drivers/net/wireless/rt2x00/rt2800.h
+++ b/drivers/net/wireless/rt2x00/rt2800.h
@@ -1982,7 +1982,8 @@
* FRAG: 1 To inform TKIP engine this is a fragment.
* MIMO_PS: The remote peer is in dynamic MIMO-PS mode
* TX_OP: 0:HT TXOP rule , 1:PIFS TX ,2:Backoff, 3:sifs
- * BW: Channel bandwidth 20MHz or 40 MHz
+ * BW: Channel bandwidth 0:20MHz, 1:40 MHz (for legacy rates this will
+ * duplicate the frame to both channels).
* STBC: 1: STBC support MCS =0-7, 2,3 : RESERVED
* AMPDU: 1: this frame is eligible for AMPDU aggregation, the hw will
* aggregate consecutive frames with the same RA and QoS TID.