PM / Domains: Add preliminary support for cpuidle, v2
On some systems there are CPU cores located in the same power
domains as I/O devices. Then, power can only be removed from the
domain if all I/O devices in it are not in use and the CPU core
is idle. Add preliminary support for that to the generic PM domains
framework.
First, the platform is expected to provide a cpuidle driver with one
extra state designated for use with the generic PM domains code.
This state should be initially disabled and its exit_latency value
should be set to whatever time is needed to bring up the CPU core
itself after restoring power to it, not including the domain's
power on latency. Its .enter() callback should point to a procedure
that will remove power from the domain containing the CPU core at
the end of the CPU power transition.
The remaining characteristics of the extra cpuidle state, referred to
as the "domain" cpuidle state below, (e.g. power usage, target
residency) should be populated in accordance with the properties of
the hardware.
Next, the platform should execute genpd_attach_cpuidle() on the PM
domain containing the CPU core. That will cause the generic PM
domains framework to treat that domain in a special way such that:
* When all devices in the domain have been suspended and it is about
to be turned off, the states of the devices will be saved, but
power will not be removed from the domain. Instead, the "domain"
cpuidle state will be enabled so that power can be removed from
the domain when the CPU core is idle and the state has been chosen
as the target by the cpuidle governor.
* When the first I/O device in the domain is resumed and
__pm_genpd_poweron(() is called for the first time after
power has been removed from the domain, the "domain" cpuidle
state will be disabled to avoid subsequent surprise power removals
via cpuidle.
The effective exit_latency value of the "domain" cpuidle state
depends on the time needed to bring up the CPU core itself after
restoring power to it as well as on the power on latency of the
domain containing the CPU core. Thus the "domain" cpuidle state's
exit_latency has to be recomputed every time the domain's power on
latency is updated, which may happen every time power is restored
to the domain, if the measured power on latency is greater than
the latency stored in the corresponding generic_pm_domain structure.
Signed-off-by: Rafael J. Wysocki <rjw@sisk.pl>
Reviewed-by: Kevin Hilman <khilman@ti.com>
diff --git a/drivers/cpuidle/governors/menu.c b/drivers/cpuidle/governors/menu.c
index 8391d93..5b1f2c3 100644
--- a/drivers/cpuidle/governors/menu.c
+++ b/drivers/cpuidle/governors/menu.c
@@ -281,6 +281,7 @@
* unless the timer is happening really really soon.
*/
if (data->expected_us > 5 &&
+ !drv->states[CPUIDLE_DRIVER_STATE_START].disabled &&
dev->states_usage[CPUIDLE_DRIVER_STATE_START].disable == 0)
data->last_state_idx = CPUIDLE_DRIVER_STATE_START;
@@ -292,7 +293,7 @@
struct cpuidle_state *s = &drv->states[i];
struct cpuidle_state_usage *su = &dev->states_usage[i];
- if (su->disable)
+ if (s->disabled || su->disable)
continue;
if (s->target_residency > data->predicted_us)
continue;