ARM: at91/USB host: specify and handle properly vbus_pin_active_low
Due to an error while handling vbus_pin_active_low in ohci-at91 driver,
the specification of this property was not good in devices/board files.
Signed-off-by: Nicolas Ferre <nicolas.ferre@atmel.com>
Acked-by: Jean-Christophe PLAGNIOL-VILLARD <plagnioj@jcrosoft.com>
Cc: stable <stable@vger.kernel.org> [3.2+]
diff --git a/arch/arm/mach-at91/at91sam9g45_devices.c b/arch/arm/mach-at91/at91sam9g45_devices.c
index 698479f..ddf210a 100644
--- a/arch/arm/mach-at91/at91sam9g45_devices.c
+++ b/arch/arm/mach-at91/at91sam9g45_devices.c
@@ -127,7 +127,8 @@
/* Enable VBus control for UHP ports */
for (i = 0; i < data->ports; i++) {
if (gpio_is_valid(data->vbus_pin[i]))
- at91_set_gpio_output(data->vbus_pin[i], 0);
+ at91_set_gpio_output(data->vbus_pin[i],
+ data->vbus_pin_active_low[i]);
}
/* Enable overcurrent notification */
@@ -188,7 +189,8 @@
/* Enable VBus control for UHP ports */
for (i = 0; i < data->ports; i++) {
if (gpio_is_valid(data->vbus_pin[i]))
- at91_set_gpio_output(data->vbus_pin[i], 0);
+ at91_set_gpio_output(data->vbus_pin[i],
+ data->vbus_pin_active_low[i]);
}
usbh_ehci_data = *data;