s390/dasd: fix disconnected device with valid path mask
Path verification is either done via dasd_eckd_read_conf() which is
triggered during online processing and resume or via
do_path_verification_work() which is triggered after path events.
The dasd_eckd_read_conf() version added paths unconditionally and did
not check if the path mask was empty. This led to devices having the
disconnected stop flag set but a valid path mask. So they where not
working although they had paths validated successfully. After a resume
this state could even not be solved with additional paths added.
Fix by checking for an empty path mask in dasd_eckd_read_conf() and
clearing the device stop bits for a newly added channel path.
Reviewed-by: Sebastian Ott <sebott@linux.vnet.ibm.com>
Signed-off-by: Stefan Haberland <stefan.haberland@de.ibm.com>
Signed-off-by: Martin Schwidefsky <schwidefsky@de.ibm.com>
diff --git a/drivers/s390/block/dasd_eckd.c b/drivers/s390/block/dasd_eckd.c
index 3d929ab..9083247 100644
--- a/drivers/s390/block/dasd_eckd.c
+++ b/drivers/s390/block/dasd_eckd.c
@@ -1171,7 +1171,12 @@
path_data->ppm |= lpm;
break;
}
- path_data->opm |= lpm;
+ if (!path_data->opm) {
+ path_data->opm = lpm;
+ dasd_generic_path_operational(device);
+ } else {
+ path_data->opm |= lpm;
+ }
/*
* if the path is used
* it should not be in one of the negative lists