[PATCH] spi: add spi master driver for Freescale MPC83xx SPI controller
This driver supports the SPI controller on the MPC83xx SoC devices from
Freescale. Note, this driver supports only the simple shift register SPI
controller and not the descriptor based CPM or QUICCEngine SPI controller.
Signed-off-by: Kumar Gala <galak@kernel.crashing.org>
Signed-off-by: David Brownell <dbrownell@users.sourceforge.net>
Cc: Greg KH <greg@kroah.com>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>
diff --git a/drivers/spi/Kconfig b/drivers/spi/Kconfig
index 9ce1d01..3867c6e 100644
--- a/drivers/spi/Kconfig
+++ b/drivers/spi/Kconfig
@@ -75,6 +75,18 @@
inexpensive battery powered microcontroller evaluation board.
This same cable can be used to flash new firmware.
+config SPI_MPC83xx
+ tristate "Freescale MPC83xx SPI controller"
+ depends on SPI_MASTER && PPC_83xx && EXPERIMENTAL
+ select SPI_BITBANG
+ help
+ This enables using the Freescale MPC83xx SPI controller in master
+ mode.
+
+ Note, this driver uniquely supports the SPI controller on the MPC83xx
+ family of PowerPC processors. The MPC83xx uses a simple set of shift
+ registers for data (opposed to the CPM based descriptor model).
+
config SPI_PXA2XX
tristate "PXA2xx SSP SPI master"
depends on SPI_MASTER && ARCH_PXA && EXPERIMENTAL