[SCSI] mptscsih: remove unused page 1 setting function
It was actually rendered unused by the move to the spi transport
class, but never taken out.
Signed-off-by: James Bottomley <James.Bottomley@SteelEye.com>
diff --git a/drivers/message/fusion/mptscsih.c b/drivers/message/fusion/mptscsih.c
index ff83e21..a218310 100644
--- a/drivers/message/fusion/mptscsih.c
+++ b/drivers/message/fusion/mptscsih.c
@@ -2786,50 +2786,6 @@
/*
* SCSI Config Page functionality ...
*/
-/*=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=*/
-/* mptscsih_setDevicePage1Flags - add Requested and Configuration fields flags
- * based on width, factor and offset parameters.
- * @width: bus width
- * @factor: sync factor
- * @offset: sync offset
- * @requestedPtr: pointer to requested values (updated)
- * @configurationPtr: pointer to configuration values (updated)
- * @flags: flags to block WDTR or SDTR negotiation
- *
- * Return: None.
- *
- * Remark: Called by writeSDP1 and _dv_params
- */
-static void
-mptscsih_setDevicePage1Flags (u8 width, u8 factor, u8 offset, int *requestedPtr, int *configurationPtr, u8 flags)
-{
- u8 nowide = flags & MPT_TARGET_NO_NEGO_WIDE;
- u8 nosync = flags & MPT_TARGET_NO_NEGO_SYNC;
-
- *configurationPtr = 0;
- *requestedPtr = width ? MPI_SCSIDEVPAGE1_RP_WIDE : 0;
- *requestedPtr |= (offset << 16) | (factor << 8);
-
- if (width && offset && !nowide && !nosync) {
- if (factor < MPT_ULTRA160) {
- *requestedPtr |= (MPI_SCSIDEVPAGE1_RP_IU + MPI_SCSIDEVPAGE1_RP_DT);
- if ((flags & MPT_TARGET_NO_NEGO_QAS) == 0)
- *requestedPtr |= MPI_SCSIDEVPAGE1_RP_QAS;
- if (flags & MPT_TAPE_NEGO_IDP)
- *requestedPtr |= 0x08000000;
- } else if (factor < MPT_ULTRA2) {
- *requestedPtr |= MPI_SCSIDEVPAGE1_RP_DT;
- }
- }
-
- if (nowide)
- *configurationPtr |= MPI_SCSIDEVPAGE1_CONF_WDTR_DISALLOWED;
-
- if (nosync)
- *configurationPtr |= MPI_SCSIDEVPAGE1_CONF_SDTR_DISALLOWED;
-
- return;
-}
/*=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=*/
/* mptscsih_writeIOCPage4 - write IOC Page 4