blob: be334da7a7549b4fb44f82e59000450875c1abfb [file] [log] [blame]
/*
* linux/drivers/ide/pci/hpt34x.c Version 0.40 Sept 10, 2002
*
* Copyright (C) 1998-2000 Andre Hedrick <andre@linux-ide.org>
* May be copied or modified under the terms of the GNU General Public License
*
*
* 00:12.0 Unknown mass storage controller:
* Triones Technologies, Inc.
* Unknown device 0003 (rev 01)
*
* hde: UDMA 2 (0x0000 0x0002) (0x0000 0x0010)
* hdf: UDMA 2 (0x0002 0x0012) (0x0010 0x0030)
* hde: DMA 2 (0x0000 0x0002) (0x0000 0x0010)
* hdf: DMA 2 (0x0002 0x0012) (0x0010 0x0030)
* hdg: DMA 1 (0x0012 0x0052) (0x0030 0x0070)
* hdh: DMA 1 (0x0052 0x0252) (0x0070 0x00f0)
*
* ide-pci.c reference
*
* Since there are two cards that report almost identically,
* the only discernable difference is the values reported in pcicmd.
* Booting-BIOS card or HPT363 :: pcicmd == 0x07
* Non-bootable card or HPT343 :: pcicmd == 0x05
*/
#include <linux/config.h>
#include <linux/module.h>
#include <linux/types.h>
#include <linux/kernel.h>
#include <linux/delay.h>
#include <linux/timer.h>
#include <linux/mm.h>
#include <linux/ioport.h>
#include <linux/blkdev.h>
#include <linux/hdreg.h>
#include <linux/interrupt.h>
#include <linux/pci.h>
#include <linux/init.h>
#include <linux/ide.h>
#include <asm/io.h>
#include <asm/irq.h>
#define HPT343_DEBUG_DRIVE_INFO 0
static u8 hpt34x_ratemask (ide_drive_t *drive)
{
return 1;
}
static void hpt34x_clear_chipset (ide_drive_t *drive)
{
struct pci_dev *dev = HWIF(drive)->pci_dev;
u32 reg1 = 0, tmp1 = 0, reg2 = 0, tmp2 = 0;
pci_read_config_dword(dev, 0x44, &reg1);
pci_read_config_dword(dev, 0x48, &reg2);
tmp1 = ((0x00 << (3*drive->dn)) | (reg1 & ~(7 << (3*drive->dn))));
tmp2 = (reg2 & ~(0x11 << drive->dn));
pci_write_config_dword(dev, 0x44, tmp1);
pci_write_config_dword(dev, 0x48, tmp2);
}
static int hpt34x_tune_chipset (ide_drive_t *drive, u8 xferspeed)
{
struct pci_dev *dev = HWIF(drive)->pci_dev;
u8 speed = ide_rate_filter(hpt34x_ratemask(drive), xferspeed);
u32 reg1= 0, tmp1 = 0, reg2 = 0, tmp2 = 0;
u8 hi_speed, lo_speed;
hi_speed = speed >> 4;
lo_speed = speed & 0x0f;
if (hi_speed & 7) {
hi_speed = (hi_speed & 4) ? 0x01 : 0x10;
} else {
lo_speed <<= 5;
lo_speed >>= 5;
}
pci_read_config_dword(dev, 0x44, &reg1);
pci_read_config_dword(dev, 0x48, &reg2);
tmp1 = ((lo_speed << (3*drive->dn)) | (reg1 & ~(7 << (3*drive->dn))));
tmp2 = ((hi_speed << drive->dn) | reg2);
pci_write_config_dword(dev, 0x44, tmp1);
pci_write_config_dword(dev, 0x48, tmp2);
#if HPT343_DEBUG_DRIVE_INFO
printk("%s: %s drive%d (0x%04x 0x%04x) (0x%04x 0x%04x)" \
" (0x%02x 0x%02x)\n",
drive->name, ide_xfer_verbose(speed),
drive->dn, reg1, tmp1, reg2, tmp2,
hi_speed, lo_speed);
#endif /* HPT343_DEBUG_DRIVE_INFO */
return(ide_config_drive_speed(drive, speed));
}
static void hpt34x_tune_drive (ide_drive_t *drive, u8 pio)
{
pio = ide_get_best_pio_mode(drive, pio, 5, NULL);
hpt34x_clear_chipset(drive);
(void) hpt34x_tune_chipset(drive, (XFER_PIO_0 + pio));
}
/*
* This allows the configuration of ide_pci chipset registers
* for cards that learn about the drive's UDMA, DMA, PIO capabilities
* after the drive is reported by the OS. Initially for designed for
* HPT343 UDMA chipset by HighPoint|Triones Technologies, Inc.
*/
static int config_chipset_for_dma (ide_drive_t *drive)
{
u8 speed = ide_dma_speed(drive, hpt34x_ratemask(drive));
if (!(speed))
return 0;
hpt34x_clear_chipset(drive);
(void) hpt34x_tune_chipset(drive, speed);
return ide_dma_enable(drive);
}
static int hpt34x_config_drive_xfer_rate (ide_drive_t *drive)
{
ide_hwif_t *hwif = HWIF(drive);
struct hd_driveid *id = drive->id;
drive->init_speed = 0;
if (id && (id->capability & 1) && drive->autodma) {
if (ide_use_dma(drive)) {
if (config_chipset_for_dma(drive))
#ifndef CONFIG_HPT34X_AUTODMA
return hwif->ide_dma_off_quietly(drive);
#else
return hwif->ide_dma_on(drive);
#endif
}
goto fast_ata_pio;
} else if ((id->capability & 8) || (id->field_valid & 2)) {
fast_ata_pio:
hpt34x_tune_drive(drive, 255);
return hwif->ide_dma_off_quietly(drive);
}
/* IORDY not supported */
return 0;
}
/*
* If the BIOS does not set the IO base addaress to XX00, 343 will fail.
*/
#define HPT34X_PCI_INIT_REG 0x80
static unsigned int __devinit init_chipset_hpt34x(struct pci_dev *dev, const char *name)
{
int i = 0;
unsigned long hpt34xIoBase = pci_resource_start(dev, 4);
unsigned long hpt_addr[4] = { 0x20, 0x34, 0x28, 0x3c };
unsigned long hpt_addr_len[4] = { 7, 3, 7, 3 };
u16 cmd;
unsigned long flags;
local_irq_save(flags);
pci_write_config_byte(dev, HPT34X_PCI_INIT_REG, 0x00);
pci_read_config_word(dev, PCI_COMMAND, &cmd);
if (cmd & PCI_COMMAND_MEMORY) {
if (pci_resource_start(dev, PCI_ROM_RESOURCE)) {
pci_write_config_dword(dev, PCI_ROM_ADDRESS,
dev->resource[PCI_ROM_RESOURCE].start | PCI_ROM_ADDRESS_ENABLE);
printk(KERN_INFO "HPT345: ROM enabled at 0x%08lx\n",
dev->resource[PCI_ROM_RESOURCE].start);
}
pci_write_config_byte(dev, PCI_LATENCY_TIMER, 0xF0);
} else {
pci_write_config_byte(dev, PCI_LATENCY_TIMER, 0x20);
}
/*
* Since 20-23 can be assigned and are R/W, we correct them.
*/
pci_write_config_word(dev, PCI_COMMAND, cmd & ~PCI_COMMAND_IO);
for(i=0; i<4; i++) {
dev->resource[i].start = (hpt34xIoBase + hpt_addr[i]);
dev->resource[i].end = dev->resource[i].start + hpt_addr_len[i];
dev->resource[i].flags = IORESOURCE_IO;
pci_write_config_dword(dev,
(PCI_BASE_ADDRESS_0 + (i * 4)),
dev->resource[i].start);
}
pci_write_config_word(dev, PCI_COMMAND, cmd);
local_irq_restore(flags);
return dev->irq;
}
static void __devinit init_hwif_hpt34x(ide_hwif_t *hwif)
{
u16 pcicmd = 0;
hwif->autodma = 0;
hwif->tuneproc = &hpt34x_tune_drive;
hwif->speedproc = &hpt34x_tune_chipset;
hwif->no_dsc = 1;
hwif->drives[0].autotune = 1;
hwif->drives[1].autotune = 1;
pci_read_config_word(hwif->pci_dev, PCI_COMMAND, &pcicmd);
if (!hwif->dma_base)
return;
hwif->ultra_mask = 0x07;
hwif->mwdma_mask = 0x07;
hwif->swdma_mask = 0x07;
hwif->ide_dma_check = &hpt34x_config_drive_xfer_rate;
if (!noautodma)
hwif->autodma = (pcicmd & PCI_COMMAND_MEMORY) ? 1 : 0;
hwif->drives[0].autodma = hwif->autodma;
hwif->drives[1].autodma = hwif->autodma;
}
static ide_pci_device_t hpt34x_chipset __devinitdata = {
.name = "HPT34X",
.init_chipset = init_chipset_hpt34x,
.init_hwif = init_hwif_hpt34x,
.channels = 2,
.autodma = NOAUTODMA,
.bootable = NEVER_BOARD,
.extra = 16
};
static int __devinit hpt34x_init_one(struct pci_dev *dev, const struct pci_device_id *id)
{
ide_pci_device_t *d = &hpt34x_chipset;
static char *chipset_names[] = {"HPT343", "HPT345"};
u16 pcicmd = 0;
pci_read_config_word(dev, PCI_COMMAND, &pcicmd);
d->name = chipset_names[(pcicmd & PCI_COMMAND_MEMORY) ? 1 : 0];
d->bootable = (pcicmd & PCI_COMMAND_MEMORY) ? OFF_BOARD : NEVER_BOARD;
return ide_setup_pci_device(dev, d);
}
static struct pci_device_id hpt34x_pci_tbl[] = {
{ PCI_VENDOR_ID_TTI, PCI_DEVICE_ID_TTI_HPT343, PCI_ANY_ID, PCI_ANY_ID, 0, 0, 0},
{ 0, },
};
MODULE_DEVICE_TABLE(pci, hpt34x_pci_tbl);
static struct pci_driver driver = {
.name = "HPT34x_IDE",
.id_table = hpt34x_pci_tbl,
.probe = hpt34x_init_one,
};
static int hpt34x_ide_init(void)
{
return ide_pci_register_driver(&driver);
}
module_init(hpt34x_ide_init);
MODULE_AUTHOR("Andre Hedrick");
MODULE_DESCRIPTION("PCI driver module for Highpoint 34x IDE");
MODULE_LICENSE("GPL");