net: mv643xx_eth: use phy_disconnect instead of phy_detach
Using a separated mdio bus driver with mvmdio, phy_detach on network device
removal will not stop the phy and finally lead to NULL pointer dereference
in mvmdio due to non-existent network device. Use phy_disconnect instead
to properly stop phy device from accessing network device prior removal of
the network device.
Signed-off-by: Sebastian Hesselbarth <sebastian.hesselbarth@gmail.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/ethernet/marvell/mv643xx_eth.c b/drivers/net/ethernet/marvell/mv643xx_eth.c
index afb8bcb..8124464 100644
--- a/drivers/net/ethernet/marvell/mv643xx_eth.c
+++ b/drivers/net/ethernet/marvell/mv643xx_eth.c
@@ -2805,7 +2805,7 @@
unregister_netdev(mp->dev);
if (mp->phy != NULL)
- phy_detach(mp->phy);
+ phy_disconnect(mp->phy);
cancel_work_sync(&mp->tx_timeout_task);
if (!IS_ERR(mp->clk))