ASoC: Intel: Skylake: Add FE and BE hw_params handling
For FE and BE, the PCM parameters come from FE and BE hw_params
values passed. For a FE we convert the FE params to DSP expected
module format and pass to DSP. For a BE we need to find the
gateway settings (i2s/PDM) to be applied. These are queried from
NHLT table and applied.
Further for BE based on direction the settings are applied as
either source or destination parameters.
These helpers here allow the format to be calculated and queried
as per firmware format.
Signed-off-by: Jeeja KP <jeeja.kp@intel.com>
Signed-off-by: Subhransu S. Prusty <subhransu.s.prusty@intel.com>
Signed-off-by: Vinod Koul <vinod.koul@intel.com>
Signed-off-by: Mark Brown <broonie@kernel.org>
diff --git a/sound/soc/intel/skylake/skl-topology.h b/sound/soc/intel/skylake/skl-topology.h
index b3a22a6..12db94d 100644
--- a/sound/soc/intel/skylake/skl-topology.h
+++ b/sound/soc/intel/skylake/skl-topology.h
@@ -280,6 +280,18 @@
return ebus_to_skl(ebus);
}
+int skl_tplg_be_update_params(struct snd_soc_dai *dai,
+ struct skl_pipe_params *params);
+void skl_tplg_set_be_dmic_config(struct snd_soc_dai *dai,
+ struct skl_pipe_params *params, int stream);
+int skl_tplg_init(struct snd_soc_platform *platform,
+ struct hdac_ext_bus *ebus);
+struct skl_module_cfg *skl_tplg_fe_get_cpr_module(
+ struct snd_soc_dai *dai, int stream);
+int skl_tplg_update_pipe_params(struct device *dev,
+ struct skl_module_cfg *mconfig, struct skl_pipe_params *params);
+
+
int skl_create_pipeline(struct skl_sst *ctx, struct skl_pipe *pipe);
int skl_run_pipe(struct skl_sst *ctx, struct skl_pipe *pipe);