Blackfin: improve CLKIN_HZ config default
Most boards use 25000000 as the default HZ, so rather than add a whole
bunch more boards, make it the default for everyone. This also fixes
randconfig builds as there was no default before.
Signed-off-by: Mike Frysinger <vapier@gentoo.org>
diff --git a/arch/blackfin/Kconfig b/arch/blackfin/Kconfig
index 5bc1360..26e4858 100644
--- a/arch/blackfin/Kconfig
+++ b/arch/blackfin/Kconfig
@@ -414,12 +414,12 @@
config CLKIN_HZ
int "Frequency of the crystal on the board in Hz"
- default "11059200" if BFIN533_STAMP
- default "27000000" if BFIN533_EZKIT
- default "25000000" if (BFIN537_STAMP || BFIN527_EZKIT || H8606_HVSISTEMAS || BLACKSTAMP || BFIN526_EZBRD || BFIN538_EZKIT || BFIN518F-EZBRD)
- default "30000000" if BFIN561_EZKIT
- default "24576000" if PNAV10
default "10000000" if BFIN532_IP0X
+ default "11059200" if BFIN533_STAMP
+ default "24576000" if PNAV10
+ default "25000000" # most people use this
+ default "27000000" if BFIN533_EZKIT
+ default "30000000" if BFIN561_EZKIT
help
The frequency of CLKIN crystal oscillator on the board in Hz.
Warning: This value should match the crystal on the board. Otherwise,