| /* |
| * Copyright 2008 Cavium Networks |
| * |
| * This file is free software; you can redistribute it and/or modify |
| * it under the terms of the GNU General Public License, Version 2, as |
| * published by the Free Software Foundation. |
| */ |
| |
| #include <linux/platform_device.h> |
| #include <linux/atomic.h> |
| #include <mach/cns3xxx.h> |
| #include <mach/pm.h> |
| |
| static int __devinit |
| cns3xxx_ohci_start(struct usb_hcd *hcd) |
| { |
| struct ohci_hcd *ohci = hcd_to_ohci(hcd); |
| int ret; |
| |
| /* |
| * EHCI and OHCI share the same clock and power, |
| * resetting twice would cause the 1st controller been reset. |
| * Therefore only do power up at the first up device, and |
| * power down at the last down device. |
| * |
| * Set USB AHB INCR length to 16 |
| */ |
| if (atomic_inc_return(&usb_pwr_ref) == 1) { |
| cns3xxx_pwr_power_up(1 << PM_PLL_HM_PD_CTRL_REG_OFFSET_PLL_USB); |
| cns3xxx_pwr_clk_en(1 << PM_CLK_GATE_REG_OFFSET_USB_HOST); |
| cns3xxx_pwr_soft_rst(1 << PM_SOFT_RST_REG_OFFST_USB_HOST); |
| __raw_writel((__raw_readl(MISC_CHIP_CONFIG_REG) | (0X2 << 24)), |
| MISC_CHIP_CONFIG_REG); |
| } |
| |
| ret = ohci_init(ohci); |
| if (ret < 0) |
| return ret; |
| |
| ohci->num_ports = 1; |
| |
| ret = ohci_run(ohci); |
| if (ret < 0) { |
| dev_err(hcd->self.controller, "can't start %s\n", |
| hcd->self.bus_name); |
| ohci_stop(hcd); |
| return ret; |
| } |
| return 0; |
| } |
| |
| static const struct hc_driver cns3xxx_ohci_hc_driver = { |
| .description = hcd_name, |
| .product_desc = "CNS3XXX OHCI Host controller", |
| .hcd_priv_size = sizeof(struct ohci_hcd), |
| .irq = ohci_irq, |
| .flags = HCD_USB11 | HCD_MEMORY, |
| .start = cns3xxx_ohci_start, |
| .stop = ohci_stop, |
| .shutdown = ohci_shutdown, |
| .urb_enqueue = ohci_urb_enqueue, |
| .urb_dequeue = ohci_urb_dequeue, |
| .endpoint_disable = ohci_endpoint_disable, |
| .get_frame_number = ohci_get_frame, |
| .hub_status_data = ohci_hub_status_data, |
| .hub_control = ohci_hub_control, |
| #ifdef CONFIG_PM |
| .bus_suspend = ohci_bus_suspend, |
| .bus_resume = ohci_bus_resume, |
| #endif |
| .start_port_reset = ohci_start_port_reset, |
| }; |
| |
| static int cns3xxx_ohci_probe(struct platform_device *pdev) |
| { |
| struct device *dev = &pdev->dev; |
| struct usb_hcd *hcd; |
| const struct hc_driver *driver = &cns3xxx_ohci_hc_driver; |
| struct resource *res; |
| int irq; |
| int retval; |
| |
| if (usb_disabled()) |
| return -ENODEV; |
| |
| res = platform_get_resource(pdev, IORESOURCE_IRQ, 0); |
| if (!res) { |
| dev_err(dev, "Found HC with no IRQ.\n"); |
| return -ENODEV; |
| } |
| irq = res->start; |
| |
| hcd = usb_create_hcd(driver, dev, dev_name(dev)); |
| if (!hcd) |
| return -ENOMEM; |
| |
| res = platform_get_resource(pdev, IORESOURCE_MEM, 0); |
| if (!res) { |
| dev_err(dev, "Found HC with no register addr.\n"); |
| retval = -ENODEV; |
| goto err1; |
| } |
| hcd->rsrc_start = res->start; |
| hcd->rsrc_len = resource_size(res); |
| |
| if (!request_mem_region(hcd->rsrc_start, hcd->rsrc_len, |
| driver->description)) { |
| dev_dbg(dev, "controller already in use\n"); |
| retval = -EBUSY; |
| goto err1; |
| } |
| |
| hcd->regs = ioremap(hcd->rsrc_start, hcd->rsrc_len); |
| if (!hcd->regs) { |
| dev_dbg(dev, "error mapping memory\n"); |
| retval = -EFAULT; |
| goto err2; |
| } |
| |
| ohci_hcd_init(hcd_to_ohci(hcd)); |
| |
| retval = usb_add_hcd(hcd, irq, IRQF_SHARED); |
| if (retval == 0) |
| return retval; |
| |
| iounmap(hcd->regs); |
| err2: |
| release_mem_region(hcd->rsrc_start, hcd->rsrc_len); |
| err1: |
| usb_put_hcd(hcd); |
| return retval; |
| } |
| |
| static int cns3xxx_ohci_remove(struct platform_device *pdev) |
| { |
| struct usb_hcd *hcd = platform_get_drvdata(pdev); |
| |
| usb_remove_hcd(hcd); |
| iounmap(hcd->regs); |
| release_mem_region(hcd->rsrc_start, hcd->rsrc_len); |
| |
| /* |
| * EHCI and OHCI share the same clock and power, |
| * resetting twice would cause the 1st controller been reset. |
| * Therefore only do power up at the first up device, and |
| * power down at the last down device. |
| */ |
| if (atomic_dec_return(&usb_pwr_ref) == 0) |
| cns3xxx_pwr_clk_dis(1 << PM_CLK_GATE_REG_OFFSET_USB_HOST); |
| |
| usb_put_hcd(hcd); |
| |
| platform_set_drvdata(pdev, NULL); |
| |
| return 0; |
| } |
| |
| MODULE_ALIAS("platform:cns3xxx-ohci"); |
| |
| static struct platform_driver ohci_hcd_cns3xxx_driver = { |
| .probe = cns3xxx_ohci_probe, |
| .remove = cns3xxx_ohci_remove, |
| .driver = { |
| .name = "cns3xxx-ohci", |
| }, |
| }; |