blob: 5d41dbe059a3ffc2e7bb655e4cac7047f5b29052 [file] [log] [blame]
/*
* Copyright (C) 2009 Texas Instruments Inc.
*
* This program is free software; you can redistribute it and/or modify
* it under the terms of the GNU General Public License version 2 as
* published by the Free Software Foundation.
*/
#include <linux/kernel.h>
#include <linux/init.h>
#include <linux/platform_device.h>
#include <linux/input.h>
#include <linux/gpio.h>
#include <asm/mach-types.h>
#include <asm/mach/arch.h>
#include <plat/common.h>
#include <plat/board.h>
#include <plat/gpmc-smc91x.h>
#include <plat/usb.h>
#include <mach/board-zoom.h>
#include "board-flash.h"
#include "mux.h"
#include "sdram-hynix-h8mbx00u0mer-0em.h"
#if defined(CONFIG_SMC91X) || defined(CONFIG_SMC91X_MODULE)
static struct omap_smc91x_platform_data board_smc91x_data = {
.cs = 3,
.flags = GPMC_MUX_ADD_DATA | IORESOURCE_IRQ_LOWLEVEL,
};
static void __init board_smc91x_init(void)
{
board_smc91x_data.gpio_irq = 158;
gpmc_smc91x_init(&board_smc91x_data);
}
#else
static inline void board_smc91x_init(void)
{
}
#endif /* defined(CONFIG_SMC91X) || defined(CONFIG_SMC91X_MODULE) */
static void enable_board_wakeup_source(void)
{
/* T2 interrupt line (keypad) */
omap_mux_init_signal("sys_nirq",
OMAP_WAKEUP_EN | OMAP_PIN_INPUT_PULLUP);
}
static const struct ehci_hcd_omap_platform_data ehci_pdata __initconst = {
.port_mode[0] = EHCI_HCD_OMAP_MODE_PHY,
.port_mode[1] = EHCI_HCD_OMAP_MODE_PHY,
.port_mode[2] = EHCI_HCD_OMAP_MODE_UNKNOWN,
.phy_reset = true,
.reset_gpio_port[0] = 126,
.reset_gpio_port[1] = 61,
.reset_gpio_port[2] = -EINVAL
};
static struct omap_board_config_kernel sdp_config[] __initdata = {
};
static void __init omap_sdp_init_irq(void)
{
omap_board_config = sdp_config;
omap_board_config_size = ARRAY_SIZE(sdp_config);
omap2_init_common_infrastructure();
omap2_init_common_devices(h8mbx00u0mer0em_sdrc_params,
h8mbx00u0mer0em_sdrc_params);
omap_init_irq();
}
#ifdef CONFIG_OMAP_MUX
static struct omap_board_mux board_mux[] __initdata = {
{ .reg_offset = OMAP_MUX_TERMINATOR },
};
#endif
/*
* SDP3630 CS organization
* See also the Switch S8 settings in the comments.
*/
static char chip_sel_sdp[][GPMC_CS_NUM] = {
{PDC_NOR, PDC_NAND, PDC_ONENAND, DBG_MPDB, 0, 0, 0, 0}, /* S8:1111 */
{PDC_ONENAND, PDC_NAND, PDC_NOR, DBG_MPDB, 0, 0, 0, 0}, /* S8:1110 */
{PDC_NAND, PDC_ONENAND, PDC_NOR, DBG_MPDB, 0, 0, 0, 0}, /* S8:1101 */
};
static struct mtd_partition sdp_nor_partitions[] = {
/* bootloader (U-Boot, etc) in first sector */
{
.name = "Bootloader-NOR",
.offset = 0,
.size = SZ_256K,
.mask_flags = MTD_WRITEABLE, /* force read-only */
},
/* bootloader params in the next sector */
{
.name = "Params-NOR",
.offset = MTDPART_OFS_APPEND,
.size = SZ_256K,
.mask_flags = 0,
},
/* kernel */
{
.name = "Kernel-NOR",
.offset = MTDPART_OFS_APPEND,
.size = SZ_2M,
.mask_flags = 0
},
/* file system */
{
.name = "Filesystem-NOR",
.offset = MTDPART_OFS_APPEND,
.size = MTDPART_SIZ_FULL,
.mask_flags = 0
}
};
static struct mtd_partition sdp_onenand_partitions[] = {
{
.name = "X-Loader-OneNAND",
.offset = 0,
.size = 4 * (64 * 2048),
.mask_flags = MTD_WRITEABLE /* force read-only */
},
{
.name = "U-Boot-OneNAND",
.offset = MTDPART_OFS_APPEND,
.size = 2 * (64 * 2048),
.mask_flags = MTD_WRITEABLE /* force read-only */
},
{
.name = "U-Boot Environment-OneNAND",
.offset = MTDPART_OFS_APPEND,
.size = 1 * (64 * 2048),
},
{
.name = "Kernel-OneNAND",
.offset = MTDPART_OFS_APPEND,
.size = 16 * (64 * 2048),
},
{
.name = "File System-OneNAND",
.offset = MTDPART_OFS_APPEND,
.size = MTDPART_SIZ_FULL,
},
};
static struct mtd_partition sdp_nand_partitions[] = {
/* All the partition sizes are listed in terms of NAND block size */
{
.name = "X-Loader-NAND",
.offset = 0,
.size = 4 * (64 * 2048),
.mask_flags = MTD_WRITEABLE, /* force read-only */
},
{
.name = "U-Boot-NAND",
.offset = MTDPART_OFS_APPEND, /* Offset = 0x80000 */
.size = 10 * (64 * 2048),
.mask_flags = MTD_WRITEABLE, /* force read-only */
},
{
.name = "Boot Env-NAND",
.offset = MTDPART_OFS_APPEND, /* Offset = 0x1c0000 */
.size = 6 * (64 * 2048),
},
{
.name = "Kernel-NAND",
.offset = MTDPART_OFS_APPEND, /* Offset = 0x280000 */
.size = 40 * (64 * 2048),
},
{
.name = "File System - NAND",
.size = MTDPART_SIZ_FULL,
.offset = MTDPART_OFS_APPEND, /* Offset = 0x780000 */
},
};
static struct flash_partitions sdp_flash_partitions[] = {
{
.parts = sdp_nor_partitions,
.nr_parts = ARRAY_SIZE(sdp_nor_partitions),
},
{
.parts = sdp_onenand_partitions,
.nr_parts = ARRAY_SIZE(sdp_onenand_partitions),
},
{
.parts = sdp_nand_partitions,
.nr_parts = ARRAY_SIZE(sdp_nand_partitions),
},
};
static void __init omap_sdp_init(void)
{
omap3_mux_init(board_mux, OMAP_PACKAGE_CBP);
zoom_peripherals_init();
board_smc91x_init();
board_flash_init(sdp_flash_partitions, chip_sel_sdp);
enable_board_wakeup_source();
usb_ehci_init(&ehci_pdata);
}
MACHINE_START(OMAP_3630SDP, "OMAP 3630SDP board")
.boot_params = 0x80000100,
.map_io = omap3_map_io,
.reserve = omap_reserve,
.init_irq = omap_sdp_init_irq,
.init_machine = omap_sdp_init,
.timer = &omap_timer,
MACHINE_END