cfg80211/mac80211: DFS setup chandef for cac event
To report channel width correctly we have
to send correct channel parameters from
mac80211 when calling cfg80211_cac_event().
This is required in case of using channel width
higher than 20MHz and we have to set correct
dfs channel state after CAC (NL80211_DFS_AVAILABLE).
Signed-off-by: Janusz Dziedzic <janusz.dziedzic@tieto.com>
Reviewed-by: Luis R. Rodriguez <mcgrof@do-not-panic.com>
Signed-off-by: Johannes Berg <johannes.berg@intel.com>
diff --git a/net/mac80211/util.c b/net/mac80211/util.c
index 592a181..fd4fe5d 100644
--- a/net/mac80211/util.c
+++ b/net/mac80211/util.c
@@ -2259,14 +2259,17 @@
void ieee80211_dfs_cac_cancel(struct ieee80211_local *local)
{
struct ieee80211_sub_if_data *sdata;
+ struct cfg80211_chan_def chandef;
mutex_lock(&local->iflist_mtx);
list_for_each_entry(sdata, &local->interfaces, list) {
cancel_delayed_work_sync(&sdata->dfs_cac_timer_work);
if (sdata->wdev.cac_started) {
+ chandef = sdata->vif.bss_conf.chandef;
ieee80211_vif_release_channel(sdata);
cfg80211_cac_event(sdata->dev,
+ &chandef,
NL80211_RADAR_CAC_ABORTED,
GFP_KERNEL);
}