KVM: x86: INIT and reset sequences are different
x86 architecture defines differences between the reset and INIT sequences.
INIT does not initialize the FPU (including MMX, XMM, YMM, etc.), TSC, PMU,
MSRs (in general), MTRRs machine-check, APIC ID, APIC arbitration ID and BSP.
References (from Intel SDM):
"If the MP protocol has completed and a BSP is chosen, subsequent INITs (either
to a specific processor or system wide) do not cause the MP protocol to be
repeated." [8.4.2: MP Initialization Protocol Requirements and Restrictions]
[Table 9-1. IA-32 Processor States Following Power-up, Reset, or INIT]
"If the processor is reset by asserting the INIT# pin, the x87 FPU state is not
changed." [9.2: X87 FPU INITIALIZATION]
"The state of the local APIC following an INIT reset is the same as it is after
a power-up or hardware reset, except that the APIC ID and arbitration ID
registers are not affected." [10.4.7.3: Local APIC State After an INIT Reset
("Wait-for-SIPI" State)]
Signed-off-by: Nadav Amit <namit@cs.technion.ac.il>
Message-Id: <1428924848-28212-1-git-send-email-namit@cs.technion.ac.il>
Signed-off-by: Paolo Bonzini <pbonzini@redhat.com>
diff --git a/arch/x86/kvm/lapic.h b/arch/x86/kvm/lapic.h
index 9d28383..793f761 100644
--- a/arch/x86/kvm/lapic.h
+++ b/arch/x86/kvm/lapic.h
@@ -48,7 +48,7 @@
int kvm_apic_accept_pic_intr(struct kvm_vcpu *vcpu);
int kvm_get_apic_interrupt(struct kvm_vcpu *vcpu);
void kvm_apic_accept_events(struct kvm_vcpu *vcpu);
-void kvm_lapic_reset(struct kvm_vcpu *vcpu);
+void kvm_lapic_reset(struct kvm_vcpu *vcpu, bool init_event);
u64 kvm_lapic_get_cr8(struct kvm_vcpu *vcpu);
void kvm_lapic_set_tpr(struct kvm_vcpu *vcpu, unsigned long cr8);
void kvm_lapic_set_eoi(struct kvm_vcpu *vcpu);