microblaze: Fix ftrace_update_ftrace_func panic
The Microblaze dynamic ftrace code assumes a call ordering that is not met
in all scenarios. Specifically, executing a command similar to:
echo 105 > /sys/kernel/debug/tracing/set_ftrace_pid
before any other tracing-related commands results in a kernel panic:
BUG: failure at arch/microblaze/kernel/ftrace.c:198/ftrace_update_ftrace_func()!
Recoding ftrace_update_ftrace_func() to use &ftrace_caller directly eliminates
the need to capture its address elsewhere (and thus rely on a particular call
sequence).
Signed-off-by: Steven J. Magnani <steve@digidescorp.com>
Signed-off-by: Michal Simek <monstr@monstr.eu>
diff --git a/arch/microblaze/kernel/ftrace.c b/arch/microblaze/kernel/ftrace.c
index 388b31c..515feb4 100644
--- a/arch/microblaze/kernel/ftrace.c
+++ b/arch/microblaze/kernel/ftrace.c
@@ -151,13 +151,10 @@
return ret;
}
-static int ret_addr; /* initialized as 0 by default */
-
/* I believe that first is called ftrace_make_nop before this function */
int ftrace_make_call(struct dyn_ftrace *rec, unsigned long addr)
{
int ret;
- ret_addr = addr; /* saving where the barrier jump is */
pr_debug("%s: addr:0x%x, rec->ip: 0x%x, imm:0x%x\n",
__func__, (unsigned int)addr, (unsigned int)rec->ip, imm);
ret = ftrace_modify_code(rec->ip, imm);
@@ -194,12 +191,9 @@
ret = ftrace_modify_code(ip, upper);
ret += ftrace_modify_code(ip + 4, lower);
- /* We just need to remove the rtsd r15, 8 by NOP */
- BUG_ON(!ret_addr);
- if (ret_addr)
- ret += ftrace_modify_code(ret_addr, MICROBLAZE_NOP);
- else
- ret = 1; /* fault */
+ /* We just need to replace the rtsd r15, 8 with NOP */
+ ret += ftrace_modify_code((unsigned long)&ftrace_caller,
+ MICROBLAZE_NOP);
/* All changes are done - lets do caches consistent */
flush_icache();