mmc: sdhci: add a quirk for single block transactions
This patch defines a quirk to disable the block count
for single block transactions.
It is a preparation and will be used by Fujitsu
SDHCI controller f_sdh30 driver.
Signed-off-by: Vincent Yang <Vincent.Yang@tw.fujitsu.com>
Signed-off-by: Ulf Hansson <ulf.hansson@linaro.org>
diff --git a/drivers/mmc/host/sdhci.c b/drivers/mmc/host/sdhci.c
index a3ecd20..c9881ca 100644
--- a/drivers/mmc/host/sdhci.c
+++ b/drivers/mmc/host/sdhci.c
@@ -904,7 +904,7 @@
static void sdhci_set_transfer_mode(struct sdhci_host *host,
struct mmc_command *cmd)
{
- u16 mode;
+ u16 mode = 0;
struct mmc_data *data = cmd->data;
if (data == NULL) {
@@ -922,9 +922,11 @@
WARN_ON(!host->data);
- mode = SDHCI_TRNS_BLK_CNT_EN;
+ if (!(host->quirks2 & SDHCI_QUIRK2_SUPPORT_SINGLE))
+ mode = SDHCI_TRNS_BLK_CNT_EN;
+
if (mmc_op_multi(cmd->opcode) || data->blocks > 1) {
- mode |= SDHCI_TRNS_MULTI;
+ mode = SDHCI_TRNS_BLK_CNT_EN | SDHCI_TRNS_MULTI;
/*
* If we are sending CMD23, CMD12 never gets sent
* on successful completion (so no Auto-CMD12).